Advertisement
4.1. Suspension Cables
To install the COL speakers with suspension
cables, replace the two flat head M6 screws
located on the top and back sides of the
speaker with M6 eye bolts. Adjust the tilt
angle by modifying the suspension cables
length. The suspension cables and M6 eye
bolts are not supplied.
The maximum allowed length of the
eye bolts thread is 20mm for the
COL4.3 and 40mm for the COL8.3.
Longer screws can damage internal
parts of the speaker.
. .
all
4 2 W
Bracket
The Wall Bracket is available as an optional
accessory for the COL speakers and allows for a
two axis adjustment of the sound beam direction.
To install the Wall Bracket remove the four flat
head screws from the back of the COL speaker
and mount on it the cabinet section of the bracket
using the screws supplied with it. Attach the wall
section of the bracket with the appropriate
hardware (not included with the bracket). Mount
the cabinet section of the bracket onto its wall
section, adjust the swivel angle and lock it with
the supplied M6 locking screw and washer.
Release the tilt locking pin,adjust the tilt angle
and lock it again by inserting the locking pin in
the appropriate openings.
4. INSTALLATION OPTIONS
cabinet section par
Wall section part
fixed on the wall
t
Advertisement
