Sony LMD-9050 Operating Instructions Manual page 21

LMD-9050/9030
APERTURE BRIGHT CHROMA PHASE
RGB/ EXT
LINE A LINE B COMPONENT SDI-1 SDI-2 SYNC SCAN
LMD-9020
APERTURE BRIGHT CHROMA PHASE
RGB/ EXT
LINE A LINE B COMPONENT SYNC SCAN
1
Press the POWER switch.
The power is turned on and the SELECT SETTING
screen appears.
S E L E C T S E T T I N G
x N O R T H A M E R I C A
• L A T I N A M E R I C A
• A F R I C A A U S T R A L A S I A
E U R O P E M I D D L E - E A S T
• A S I A E X C E P T J A P A N
• J A P A N
2
Press the M or m button to select the area where you
intend to use the unit and press the , or ENTER
button.
If you select either LATIN AMERICA or ASIA
EXCEPT JAPAN, one of the following screens
appears.
CONTRAST VOLUME
RESET MENU
POWER
BLUE
ASPECT MARKER ONLY MONO ENTER
KEY INHIBIT
2~3 1
CONTRAST VOLUME
RESET MENU
POWER
BLUE
ASPECT MARKER ONLY MONO ENTER
KEY INHIBIT
2~3 1
North America
1
2 Latin America
3 Africa Australia/New
Zealand, Europe, Middle
East, Russia
Asia Except Japan
4
Japan
5
2 If LATIN AMERICA is selected:
L A T I N A M E R I C A
x P A L & P A L - N A R E A
A R G E N T I N A
P A R A G U A Y
U R U G U A Y
• N T S C & P A L - M A R E A
O T H E R A R E A
4 If ASIA EXCEPT JAPAN is selected:
Customers who will use this unit in the shaded
areas shown in the map below should select NTSC
AREA.
Other customers should select PAL AREA.
A S I A E X C E P T J A P A N
x N T S C A R E A
• P A L A R E A
3
Press the M or m button to narrow the area further
and then press the , or ENTER button.
The SELECT SETTING screen disappears and the
menu item settings suitable for the selected area are
applied.
Note
When you have selected the wrong area, set the
following items using the menu.
COLOR TEMP (on page 25)
COMP LEVEL(on page 26)
NTSC SETUP (on page 26)
See "The default setting values for each area" (on
page 20) on the setting value.
PAL&PAL-N area
Argentina
Paraguay
Uruguay
NTSC&PAL-M area
Other area
NTSC area
PAL area
21
Selecting the Default Settings