Technical Data - Profi Cook PC-ES 1109 Instruction Manual

Problem Possible cause
Espresso escapes at
the filter holder edge.
The filter holder is not properly attached
or is not enough closed.
Too much coffee grounds in the filter
insert.
Coffee grounds residues on the rubber
seal of the group head.
After preparing milk foam, the appli-
ance is still under pressure.
Espresso is too cold. The cups were not pre-heated.
Indicator lamp (8) does not light up
during the brewing process.
Coffee crema is The coffee grounds are too coarse or
slightly discoloured are not evenly spread.
(coffee runs out fast).
Too little coffee grounds in the filter
insert.
Coffee crema is dark The coffee grounds are too fine or
discoloured (coffee compressed too much.
runs out slowly).
Too much coffee grounds in the filter
insert.
No crema on the The espresso grounds are not suitable. Change the brand, if necessary.
espresso.
The milk does not The milk is not suitable.
froth.
The milk is not cold enough.
The steam nozzle is dirty.
This is not a malfunction of the
The appliance turns
off automatically. appliance. In order to comply with the
Ecodesign Directive (2009/125/EC),
the appliance turns off automatically
after max. 30 minutes after the brewing
process has finished.

Technical Data

Model:.........................................................PC-ES 1109
Power supply:.................................. 220 - 240 V~, 50 Hz
Power rating: ......................................................1050 W
Capacity: ........................................................ max. 1,5 ℓ
Protection class: ............................................................
Pressure: ..............................................................15 bar
Net weight: .............................................. approx. 4,6 kg
The right to make technical and design modifications
in the course of continuous product development
remains reserved.
64
PC-ES1109_IM
Solution
Stop the brewing process!
Attach the filter holder properly as instructed
under "Attach / Detach Filter Holder".
Remove excess coffee grounds. Observe the
MAX marking in the filter insert.
Switch the appliance off and let it cool
down.
Clean the rubber seal as instructed.
Release the pressure completely. Pay attention
to item 4 of the chapter "Making Espresso".
Rinse the cups with hot water.
Wait until the indicator lamp (8) lights up.
Use the supplied tamper.
Fill coffee grounds only to MAX marking in the
filter insert.
Loosen the coffee grounds. Spread it evenly
and only slightly compress with the tamper.
Use less coffee grounds. Observe the MAX
marking in the filter insert.
Use milk with at least 3.5 % fat content.
Use refrigerated milk.
Clean the steam nozzle as instructed.
This device has been tested according to all relevant
current CE guidelines, such as electromagnetic
compatibility and low voltage directives, and has
been constructed in accordance with the latest safety
regulations.
21.04.16