Notes On Use; Placement; Push Button (9); Rotary Switch (3) - Profi Cook PC-ES 1109 Instruction Manual

8 Heater indicator lamp (green)
9 push button (Espresso / Steam)
10 On- / off button (ON / OFF)
11 Status indicator lamp (red)
12 Warming plate / cup tray
13 Filter insert for 1 cup
14 Filter insert for 2 cups
15 Filter holder
16 Filter safeguard
17 Measuring spoon / tamper (1 part, 2 functions)

Notes on Use

Placement

• Place the appliance on a stable and level surface.
• Due to rising heat and vapours do not operate the
appliance under wall cabinets.
• Do not place the appliance in close proximity to a
gas or electric stove or any other heat source.
Push Button (9)
This control is a push-button switch with the following
functions when pressed or not pressed:
Push Button Disengaged
9
(Espresso)

Rotary Switch (3)

Center
Left
Brew espresso Off

Electric Connection

1. Ensure that your mains power corresponds with the
specifications of the appliance. The specifications
are printed on the type label.
2. Check the push button settings! The
push-button switch must not be pressed, and the
rotary switch must be at the center position.
3. Connect the mains cable to a properly installed and
earthed wall outlet.

On / Off

• Press the on / off button (10) briefly to switch the ap-
pliance on. The status indicator lamp (11) lights up.
The appliance starts heating up. The warming plate
(12) heats up.
• The Indicator lamp (8) lights up as soon as the nec-
essary brewing temperature is reached.
PC-ES1109_IM
NOTE:
The indicator lamp (8) turns on and off during oper-
ation. This is normal and indicates that the temper-
ature is thermostat-controlled and maintained.
• In order to switch the appliance off, press and hold
the on / off button (10) for 4 seconds. Then discon-
nect the mains plug from the socket.

European Regulations on Energy Saving

NOTE:
The European Directive 2009/125/EC (Ecodesign
Directive) incorporates measurements for energy
saving.
The following applies to coffee makers: The keep-
warm period is limited to max. 30 minutes after which
the appliance turns off automatically.
You benefit from better safety and lower energy
consumption.
WARNING: Important!
Before use, always check the button settings! Before
Engaged
you connect the appliance to a correctly installed
(Steam)
grounded socket, the
not be pressed, and the rotary switch must be at the
position!
Right

Attach / Detach Filter Holder

Steam
• Hold the handle at the left edge of the appliance to
attach the filter holder (see Fig. B on page 3). In-
sert the three guide tabs in the group head recess-
es. With the handle pull the filter holder to the right
hand side to the middle of the appliance. Ensure
that the filter holder is well secured in the group
head.
• Pull the filter holder to the left to detach from the
group head.
WARNING: Danger of burns!
After brewing the metal parts of filter holder and
filter insert are hot.

Inserting the Drip Tray / Drip Tray Grid

• Slide the drip tray for the residual water (6) into the
compartment (5).
• Place the drip tray grid (7) onto the compartment
as a cover. The recessed edge must face the appli-
ance housing.

Operation

push-button switch must
21.04.16
59