Table of Contents
Advertisement
Quick Links
4037250/4
Installation and Maintenance Instructions
Printed in the UK
IM-P403-83 AB Issue 4
SSC20
Sanitary Sample Cooler
IM-P403-83
1. Safety information
2. General
product information
3. Installation
4. Commissioning
5. Operation
6. Maintenance
7. Spare parts
8. Certificate
of conformity
© Copyright 2008
AB Issue 4
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Spirax Sarco SSC20
Summary of Contents for Spirax Sarco SSC20
- Page 1 4037250/4 IM-P403-83 AB Issue 4 SSC20 Sanitary Sample Cooler Installation and Maintenance Instructions 1. Safety information 2. General product information 3. Installation 4. Commissioning 5. Operation 6. Maintenance 7. Spare parts 8. Certificate of conformity Printed in the UK © Copyright 2008...
- Page 2 IM-P403-83 AB Issue 4...
-
Page 3: Intended Use
Group 2 of the above mentioned Pressure Equipment Directive. The products’ use on other fluids may be possible but, if this is contemplated, Spirax Sarco should be contacted to confirm the suitability of the product for the application being considered. -
Page 4: Pressure Systems
1.9 Tools and consumables Before starting work ensure that you have suitable tools and /or consumables available. Use only genuine Spirax Sarco replacement parts. 1.10 Protective clothing Consider whether you and / or others in the vicinity require any protective clothing to protect against the hazards of, for example, chemicals, high/low temperature, radiation, noise, falling objects, and dangers to eyes and face. -
Page 5: Residual Hazards
1.16 Returning products Customers and stockists are reminded that under EC Health, Safety and Environment Law, when returning products to Spirax Sarco they must provide information on any hazards and the precautions to be taken due to contamination residues or mechanical damage which may present a health, safety or environmental risk. -
Page 6: General Product Information
2. General product information Description The Spirax Sarco SSC20 sanitary sample cooler has been specifically designed for taking high quality chemical, conductivity and microbiological samples quickly and safely from clean / pure steam, water for injection (WFI) and other high purity media systems. - Page 7 Sizes and pipe connections ½" BSP BSP version Cooling water inlet and outlet connections ½" NPT NPT version ½" adaptor for clamp fitting Sample tube inlet and (clamp not supplied) on sample inlet. outlet connections 6 mm O / D on sample outlet. Limiting conditions Part Design temperatures...
-
Page 8: Installation
The sample cooler must be mounted vertically, using the pre-drilled top and bottom mounting brackets (see Figure 3). Allow sufficient space below the SSC20 for collection of the sample in a beaker or similar container. We recommend that a tundish piped to drain is located underneath this outlet. -
Page 9: Operation
4. Commissioning After installation or maintenance carry out tests to ensure that the system is fully functional. 5. Operation Warning:- To avoid the risk of scalding, it is essential that a full flow of cooling water is present before opening the sample inlet valve. Always close the sample inlet valve before turning off the cooling water. - Page 10 IM-P403-83 AB Issue 4...
- Page 11 IM-P403-83 AB Issue 4...
- Page 12 IM-P403-83 AB Issue 4...
Need help?
Do you have a question about the SSC20 and is the answer not in the manual?
Questions and answers