KETRON SD4 Owner's Manual page 37

• Edit the value using the value+/- keys.
edItIng the mIdI out parameter.
• To Hold key 9 down. The display shows "OUT" and then the value set, which is represented
as follows:
o "1 2" - Both Midi In 1 and Midi In 2 ports are connected to the Midi Out port. The effect
is that of a Soft Thru of both Midi In ports.
o "1 " - Just Midi In 1 port is connected to the Midi Out port. The effect is that of a Soft
Thru of just the Midi In 1 port.
o "2" - Just Midi In 2 port is connected to the Midi Out port. The effect is that of a Soft
Thru of just the Midi In 2 port.
o "oFF" - Neither of the two Midi In ports is connected to the Midi Out port.
• Holding key 9 down again, edit the value using the value+/- keys.
Pay attention to the Midi Out parameter if connected via USB. Since the virtual USB MIDI ports are
duplicates of the real ports, when you connect the sd4 instrument to a computer via USB, a virtual
connection will be established to both Midi In ports and the Midi Out port. If the Midi Out parameter
is not set in "OFF", when working with a sequencer, where the Thru function is enabled, you risk
generating a loop in the Midi messages. In this case, you need to set the Midi Out parameter of the
sd4 instrument in "OFF" or disable the Thru function of the sequencer.
FunCtIon menu
In this menu you can change some settings of the instrument, such as the Global Tune, the
type and general level of the Reverb and also activate the intelligent transposer mode for
Midifiles.
edItIng the global tune oF the Instrument.
• Press the Function key. The relative LED starts blinking and the display shows the value
of the global tune currently set.
• Using the value +/- keys, edit the value set in the range from -50 to +50 cents.
Other parameters can be edited using the numerical
keypad. Likewise for editing the preset, it does inde-
ed activate various functions based on the number
of the key pressed. If you hold one of the numbers
down, the display first shows the 3-letter initial that
indicates which parameter you are editing, then, af-
ter a few seconds, the relative value. For example, to
edit the global volume of the Reverb, simply hold key
3 down and the display will first show "VOL" and then
the relative value. Again, holding key 3 down, simply
press the Value +/- keys to increase or decrease the
Reverb amount. Here's the map of the functions of
each individual key of the numerical keypad within
the Function menu.
enablIng and dIsablIng the "IntellIgent transposer" FunCtIon.
• Hold key number 1 down. The display shows "INT" and then the status, which may be "ON"
or "OFF".
37