SAFETY Safety is always a concern at Ranger Tugs. Please read all manuals to ensure that equipment is used in a safe manner. We highly recommend attendance in a Coast Guard approved boating safety course. Such courses are available from the Coast Guard directly or from boating organizations.
SYMBOL GLOSSARY Attention! – Important Operating or Maintenance Instructions Attention! – Electrical Shock Hazard Fresh Water Black Water Fuel Standard Equipment Optional Equipment Hints...
PORT FIT TINGS 1 2 5 6 7 8 10 11 12 3 4 9 Keep all vents, drains and exhausts clear of any obstructions to ensure proper performance of each system. ➊ ➌➍➎ ➏➐ ➋ ➓ ➑ ➒ ➊ ➐...
Dash 1 Navigation FUSE LOCATION & VALUES Tv #1 Switch Panel (4 switch) Tv #2 Switch Panel (8 switch) Transducer Network Antenna Switch Panel (8 switch) Radar Head Light Switch (Vberth) Radar Webasto Remote 12V Outlet (dinette) The DC fuse blocks, windlass breaker and head breaker are located behind the helm, accessed Webasto Heater through the top teak cabinet in the v-berth.
POWER DISTRIBUTION PANEL (P.D.P) This Power Distribution Panel is located underneath the cockpit sink. Once the EMERGENCY PARALLEL switch is placed in the on position the power from the HOUSE batteries will be transferred to the ENGINE battery. Use only for EMERGENCY starting.
DC DISTRIBUTION PANEL, DC BANK METER The bilge pumps operate automatically with electronic float switches even when all switches and breakers are in the OFF position. However, the BILGE PUMP and BILGE PUMP2 will run continuously once their switches are placed in the on position.
AC DISTRIBUTION PANEL & ROTARY SWITCH AC Distribution Panel AC Rotary Selector Switch (Available with Generator) AC Main Line 2 (with AC) AC Main 1 when “on” will automatically AC MAIN LINE 1 turn on the charger/inverter combo unit to “charge mode”. When turned “off” REVERSE POLARITY the combo unit automatically goes into...
12V HELM CONTROL OPERATION The high bilge alarm should be set to the “armed” position for it to automatically operate. This is wired directly to battery power at the house cutoff switch. The high bilge alarm will still be active when the main battery cutoff switches are set to the off position.
FUEL SYSTEM, ENGINE, GENERATOR & WEBASTO FURNACE Volvo D4-300 180 gallon fuel tank There is a secondary on engine fuel filter that is not shown on this drawing. You will be able to find information about this filter in the diesel engine manual supplied with your boat. The water fuel sensor is located on the engine mounted filter.
CLOSED ENGINE COOLING SYSTEM Provides alternate heating system for the Fresh Water Heater and provides primary heating source for the Forced Air Cabin Heater. This system is also designed to provide cooling to the internal components of your engine. Please refer to your engine operations manual for more information.
SEA STRAINER SYSTEM Multi Port Sea Strainer for engine and raw water wash down. NW Editions have individual strainers & valves. AC pump Generator intake shutoff Washdown intake shutoff Generator sea strainer AC sea strainer Engine Washdown sea strainer AC intake shutoff Engine sea strainer Engine intake shutoff Generator...
WEBASTO FURNACE Webasto furnace is located under access panel below refrigerator. The control panel is located at the mid cabin power management center. The fuel pump is in the salon floor hatch compartment inside of the black box. Vent Forward Air Intake Grill (keep uncovered) Vent Vent...
SOLAR PANEL Solar panel 160 watt, with display panel • The solar panel is designed to provide charging to the house & engine batteries. 90% of its charge is dedicated to the house battery and 10% is dedicated to the engine battery. •...
POWER PANEL AND SOLAR PANEL CONTROLLER BOX Located in the starboard side cockpit lazerette 50 Amp Breaker Command Bridge 50 Amp Breaker 150 Amp Breaker Sedan 300 Amp ANL Bus Fuse Automatic Charging Automatic Charging Solar Panel Controller Relay (ACR) Relay (ACR)
AIR CONDITIONING A/C Vent Forward A/C Unit (Under Berth) Forward A/C Air Intake Grill (keep uncovered) Front A/C Control Panel A/C Vent A/C Vent Main Cabin A/C Unit (Under Helm Seat) Main Cabin A/C Air Intake Grill (keep uncovered) Main Cabin A/C Control Panel A/C Raw Water Pump Multi Strainer...
RAW WATER WASH DOWN Johnson Aqua Jet 5.2 GPM Washdown intake shutoff Engine Washdown sea strainer Raw water washdown Raw water washdown hose pump & filter fitting & on/off switch...
FRESH WATER PLUMBING SYSTEM 60 Gallon Fresh Water Tank, 11 Gallon Hot Water Heater, 3.5 GPM Fresh Water Pump Water pressure switch is located on the DC breaker panel H-23 7/14 APPENDIX - POTABLE WATER SYSTEMS The information contained in this appendix provides supplementary data about disinfecting a potable water system. A SUGGESTED METHOD OF DISINFECTION Perform the following steps in the order indicated: Flush entire system thoroughly by allowing potable water to flow through it;...
SHOWER SUMP 12V, 800 GPH (This should be inspected for debris on a regular basis if shower is used frequently.) The shower sump box is located underneath the island berth in the forward stateroom. Shower Sump...
BILGE PUMP SYSTEM 12V 1100GPH The bilge pumps operate automatically with electronic float switches even when all switches and breakers are in the OFF position. However, the BILGE PUMP and BILGE PUMP2 will run continuously once their switches are placed in the on position.
WASTE SYSTEM WITH MACERATOR PUMP 40 Gallon Tank with standard pump out, and vent Macerator pump out Waste tank level can be checked by utilizing the head control panel. Please refer to your head operations manual. Waste tank pump out stations are widely available. Please follow the directions carefully for the pump out equipment you are using to avoid damage to the waste system.
MAST AND BRIDGE SET UP AND TAKEDOWN SEDAN MAST SET UP PROCEDURE 1. Remove the three black plastic wing nuts from the mast base. 2. Remove the two mast tie down cables from their storage positions in the roof clips. 3.
RANGER TUG R-31 WIRING SCHEMATIC (P.D.P.) R-31 Power Distribution ELECTRICAL SCHEMATIC To Generator Control Panel 4 RED 4 RED To Bridge Fuse Block 6 RED To AC Panel (Optional) 150A HOUSE 3/O RED 1 RED 1 RED To D.C. Breaker Panel (Optional) 150A SWITCH...
CARE AND MAINTENANCE The following checklists are examples and are not all inclusive and are provided only as a guide. Please customize to your personal needs. Consult your engine and trailer user manuals for ad- ditional information. EXAMPLE OF A PREPARATION FOR THE ROAD CHECKLIST TOW VEHICLE –...
EXAMPLE OF A SPRING PRE-LAUNCH CHECKLIST CLEANING Remove debris from scuppers and scupper drains. £ Clean hull using a mild biodegradable detergent and then wax. £ Clean topsides and decks using a mild biodegradable detergent and then wax. £ Clean and polish all bright work. £...
EXAMPLE OF WINTER STORAGE CHECKLIST GENERAL MAINTENANCE Fill Fuel Tank and add a fuel stabilizer. £ Empty and clean black water tank. £ Empty fresh water tank use a non-toxic antifreeze per manufacturer’s directions. £ Winterize black and fresh water tanks as necessary based on weather. £...
All rights reserved. Reproduction or translation by any means in whole or in part is not permitted without written authorization from Ranger Tugs. The information contained herein is correct to the best of Ranger Tugs knowledge and the contents may change without notice and without incurring obligation.