Table of Contents
Advertisement
VCW & VCD SERIES CHIP WARMER
ELECTRICAL CODES & STANDARDS:
The warmer must be installed in
accordance with:
In the United States of America:
1.
State and Local Codes.
2.
National Electrical Code, ANSI/
NFPA-70 (latest edition.) Copies
may be obtained from:
National
Association, Batterymarch Park,
Quincy, MA 02269.
In Canada:
1.
Local Codes.
2.
Canadian Electrical Code, CSA
C22.1 (latest edition.)
may be obtained from:
Canadian Standard Association,
178 Rexcale Blvd., Etobicoke,
Ontario, Canada M9W 1R3.
ELECTRICAL CONNECTIONS:
The warmer is factory wired for 110/120
volt single phase operation. All 110/120
volt warmers are equipped with a 8 foot
cord and NEMA 5-15 plug as standard
equipment. Refer to wiring diagram in
the back of this manual.
The cord and plug supplied is a suitable
durable cord with a molded three-prong
plug, and is provided with a proper
strain relief.
ELECTRICAL REQUIREMENTS
The
Fire
Protection
Copies
The
equipped with a three-prong plug. It
is imperative that this plug must be
connected into a properly grounded
three-prong
receptacle
is
grounding
electrician.
grounding prong from this plug.
Verify that the power source matches
the Serial Data Plate located on the
lower back corner of the warmer and
the plug configuration before the
connection is made. (Fig. 4)
SERIAL DATA PLATE
A separate disconnect switch or circuit
breaker is recommended to be placed at
a convenient location between the Chip
Warmer and the electric power source.
To avoid damage to the power supply
cord, cord retainer bushing, or electrical
outlets, always check to be certain that
the power cord is unplugged from the
power source before moving the unit.
5
F-38053 (08-14)
All
warmers
receptacle.
If
not
the
proper
type,
contact
Do not remove the
(Fig. 4.)
are
the
an
Hide quick links:
Advertisement
Table of Contents
