Accessing The Camera Using The Web Browser; Upgrading The Firmware - Sony BRC-X1000 Firmware Upgrade Manual

Upgrading the firmware

An IP address must be set for the camera to upgrade the
firmware. For how to set an IP address of the camera,
refer to "RM-IP10 Setup Tool Guide."
You will also need a PC as you use a Web browser to
upgrade the firmware.
Notes
• Do not turn off the camera while you are upgrading the
firmware.
• It takes approximately 10 minutes to upgrade the
firmware. You cannot access the camera while the
upgrading is in progress. You also will not see any
image while the upgrading is in progress.
Before starting the
operation
Setting-up the PC
One of the following system configurations is required
for the PC:
OS
Windows 8.1 Pro (32-bit version, 64-bit version)
Windows 10 Pro (32-bit version, 64-bit version)
Web browser
Windows Internet Explorer Ver. 11.0
Notes
• In the case of Windows 8.1, use the Internet Explorer
desktop user interface (desktop UI) version.
• Turn off tablet mode when using Windows 10.
• Every page is optimized for Internet Explorer in
Medium font size.
• The Web page displayed when you log in to the
camera is made using JavaScript. The Web page may
not display correctly if your computer uses certain
software, such as anti-virus software.
Accessing the camera using the
Web browser
Start the Web browser on the computer and type the IP
address of the camera in the address bar.
A user ID and password authentication is required to
access the camera. The user ID and factory-set password
of the camera are as follows:
User name: admin
Password: Admin_1234
2