Putting The Receiver Unit Into Operation; Transmission Distance Inspection - Computherm Q7RF Operating Instructions Manual

2 . P U T T I N G T H E R E C E I V E R U N I T
I N T O O P E R AT I O N
Turn on the power supply to the receiver unit. Press the
"M/A" button of the receiver unit and keep it depressed
(for approximately 10 seconds) until the green LED
starts flashing. Following this, synchronize the thermo-
stat with the receiver unit(s) according to the instruc-
tions for use of your room thermostat. The synchroniza-
tion was successful if the green LED stops flashing and
goes out, so that the receiver unit "learns" the safety
code of the transmitter (thermostat). The safety code
will not be lost even during a power outage, the device
memorizes it automatically.
3. TRANSMISSION DISTANCE INSPEC-
TION
You can check proper functioning of wireless (RF) con-
nection between the wireless (RF) thermostat and the
receiver units by following instructions for use provided
for the thermostat being used.
- 11 -