Before Startup; Start Up - Kärcher HD 4.5/32-4 S Eb Instructions Manual

vices marked with this symbol must not
be disposed of with regular household
rubbish.
Notes about the ingredients
(REACH)
You will find current information about
the ingredients at:
www.kaercher.com/REACH

Before Startup

Unpacking
Check the contents of the pack be-
–
fore unpacking.
In case of transport damage inform
–
vendor immediately.
Check oil level
Read the oil level display when the

device is not running. The oil level
must be above the two pointers.
Activate deaeration of oil
container
Unscrew the fastening screws of

the device hood; remove the device
hood.
Cut off tip of oil container cover

Fasten the device hood.

Install hand spray gun, spray
lance and nozzle
Note: The EASY!Lock system joins
components with a quick-fasten thread
solidly and securely with just one turn.
1.
8
2.
Insert the high pressure nozzle onto

the spray lance.
Install union nut and hand-tighten it

(EASY!Lock).
Join the spray lance with the trigger

gun and tighten until hand-tight
(EASY!Lock).
Join the high-pressure hose with

trigger gun and high-pressure con-
nection of the appliance and tighten
until hand-tight (EASY!Lock).
Lock in the cable hook in the side-

hole on the handle.
WARNING
Risk of injury! Appliance, accessories,
supply lines and connections must be
in fault-free condition. If they are not in
a perfect state then the appliance must
not be used.
Electrical connection
DANGER
Danger of injury by electric shock.
It is imperative to connect the appli-
–
ance to the electric mains by means
of a plug. It is forbidden to perma-
nently connect the appliance to the
power supply. The plug serves for
the disconnection from the mains.
The appliance may only be con-
–
nected to alternating current.
Minimum fuse strength of the sock-
–
et (see Technical Data).
The highest allowed net impedance
–
at the electrical connection point
(refer to technical data) is not to be
exceeded. In case of confusion re-
garding the power impedance pre-
sent on your connection, please
contact your utilities provider.
Use the extension cord that has an
–
adequate cross-section (see "Tech-
– 6
EN

Start up