Sony BRAVIA KDL-40V5100 Getting Started Manual page 32

Getting Started Operating the TV
Getting Started > Connecting the TV
PC
Use the TV as a monitor for your PC by connecting a HD15-HD15 cable as shown below. This TV can also be connected to a PC with a DVI or HDMI output.
(Refer to the separate Quick Setup Guide.)
Connect the PC IN jack to the PC using an HD15- HD15 cable with ferrite core (analog RGB) and audio cable.

If the PC is connected to the TV and no signal has been input from the PC for more than 5 minutes, the TV enters the standby mode automatically. Refer to

the PC Power Management option under
PC and HDMI Input Signal Reference Chart
After connecting the PC to the TV, set the output signal from the PC according to the supported resolutions and timings indicated below.
Supported Resolutions
Signal Horizontal (Pixel)
VGA 640
SVGA 800
XGA 1,024
WXGA 1,280
1,360
SXGA 1,280
HDTV 1,920
This TV's PC input does not support Sync on Green or Composite Sync.

This TV's PC VGA input does not support interlaced signals.

Adjust Phase to eliminate horizontal lines of the picture when the TV receives an input signal from the connected PC.

Back to HD Cable Box/HD Satellite Box
Home | Getting Started | Operating the TV | Using Features | Using the Menus | Other Information | Specifications
Using Features
> PC
Setup Menu.
x Vertical (Line)
x 480
x 600
x 768
x 768
x 768
x 1,024
x 1,080
Copyright © 2009 Sony Electronics Inc. All rights reserved.
Using the Menus Other Information
Horizontal Vertical
frequency (kHz) frequency (kHz)
31.5
37.9
48.4
47.8
47.7
64.0
67.5
Specifications
Standard
60 VGA
60 VESA Guidelines
60 VESA Guidelines
60 VESA
60 VESA
60 VESA
60 CEA-861
Next to Other Equipment