CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water 1 General Information / Safety Instructions 1.1 General information ......................2 1.1.1 Field of use ........................2 1.1.2 Operator obligations ..................... 3 1.2 Safety instructions ......................3 1.2.1 Safety regulations ......................
Chapter 1 - General Information / Safety Instructions 1.1 General Information CLARIMAX 1200 DM pH+ LED is a water treatment system for deionization of make-up water for heating systems according to different European guidelines, such as VDI 2035, ÖNORM H 5195, SWKI BT 102-01, and protects heating systems agains limescale deposits that might cause different malfuctions or damages.
• CLARIAMX must not be operated in potentially explosive atmospheres. • CLARIMAX must only be used in perfect condition. • CLARIMAX must only be used for treatment of tap water with a quality according to the local tap water law. Treatment of acids, alkalis, etc. is not permitted.
Feed water used for CLARIMAX 1200 pH+ LED water treatment system should only be untreated tap water. CLARIMAX is only to be used with cold water within the water inlet temperature range specified in the technical data. Microbiologically contaminated water or water of unknown quality must not be used without appropriate desinfection.
CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water 1.3 Technical description 1.3.1 Electrical data CLARIMAX 1200 pH+ LED is equipped with an integrated electrical conductivity meter. An external power supply is necessary for its operation. Power supply: Power adapter DC 12V 1.3.2 Physical data...
4 ..Floor brackets 5 ..Housing handles Note There is an integrated electrical device in the filter head of CLARIMAX 1200 DM pH+ LED for capacity control. You need an external power adapter for operation of this device. Attention Please pay attention to the technical data and to the operation and security instructions prior assembly and comissioning.
CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water 2.2 Scope of delivery For installation of an CLARIMAX 1200 DM pH+ LED you need the pressure housing (incl. filter cartridge) and the filter head. Please check the scope of delivery prior use: •...
As soon as the system is ready for operation you can fill the heating system as usual. The filter treats the water in a single flow through principle. The inlet of CLARIMAX is to be connected to the mains tap water supply and the outlet of CLARIMAX with the heating system.
The batteries are not charged in the state as delivered and therefore should be charged for at least 24 hours. You can operate CLARIMAX either in mains supply mode with the power adapter or in battery mode. A fully charged battery allows 48 hours operation.
CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water 3.5.1.2 Description LED display The optical LED display is divide into three areas, which are modeled after the traffic light system. The LED lights change their color and the illuminated area with increased cartridge exhaustion.
CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water 3.5.1.4 Interval measurement (Short-term-mode) The interval measurement is activated by a single press of the F-key. The status indicator flashes as long as the device is active.
3.7 Warranty The CLARIMAX 1200 DM pH+ LED filter system is subject to the statutory warranty of 2 years. A warranty claim can only be asserted if all instructions in this manual are followed and observed.
Page 14
CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water Page 13 www.elector-water-treatment.com...
Page 15
CLARIMAX 1200 DM pH+ LED – Water-filter-system for treatment of heating-system make-up water www.elector-water-treatment.com Page 14...