Sony Bravia KDL-40D3000, KDL-32XBR4 Operating Instructions Manual page 33

Auto Wide
4:3 Default
Select the default screen
mode to use for 4:3
sources
Display Area
Screen Position
Vertical Size
Screen settings for PC timings (HDMI or PC input) differ from all other input modes and are shown below.
Auto Adjust
Reset
Phase
Pitch
H Center
V Center
On Automatically changes Wide Mode setting based upon content. If
frequent screen changes are disturbing to you, select Off.
Off Turns off the Auto Wide option. Choose a Wide Mode from the
Wide Mode option.
Wide Zoom
Enlarges the 4:3 picture to fill the 16:9 screen, displaying as much of
the original image as possible.
Normal Displays the 4:3 picture in its original aspect ratio.
Full Select to enlarge the 4:3 picture horizontally only, to fill the screen.
Zoom Select to enlarge the picture horizontally and vertically to fill the
screen while maintaining the aspect ratio.
Off Select to continue using the current Wide Mode setting when the
channel or input is changed.
~
• This option is not available if Auto Wide is set to Off.
• If 4:3 Default is set to anything but Off, the Wide Mode setting applies only to the
current channel. When you change channels (or inputs), Wide Mode is automatically
replaced with the 4:3 Default setting for 4:3 sources. To retain the current Wide Mode
setting as channels and inputs are changed, set 4:3 Default to Off.
Normal Displays the picture in its original size.
-1/-2
Enlarges the picture to hide the edge of the picture.
Adjust the Vertical positioning by pressing the V/v buttons. Press the B/b buttons to
adjust the Horizontal positioning.
~
• Screen Position option is available for standard-definition signals only. Vertical
adjustment is available only when Wide Mode is set to Zoom.
• Screen Position feature is useful if the TV is connected to game equipment.
Adjusts the vertical size of the picture. (Available only in Wide Zoom and Zoom.)
Press B/b and press to adjust.
Select Yes to start the auto adjust to display the PC input.
Resets the current screen settings to the default values.
Adjust after Pitch to fine tune overall sharpness.
Adjust uneven sharpness on screen.
~
• For the PC input Signal Reference Chart, see page 18.
Allows you to move the position of the picture horizontally (left and right).
To Adjust the H Center
Press V/v to highlight H Center and press
Press B/b to correct the centering then press
Allows you to move the position of the picture vertically (up and down).
To Adjust the V Center
Press V/v to highlight V Center and press
Press B/b to correct the centering then press
.
.
.
.
(Continued)
33