Makita DSL800 Instruction Manual page 11

Installing or removing the pad
► 1 . Hex wrench 2. Bolt 3. Pad
To remove the pad, remove the abrasive disc from the
pad, and then turn the bolt counterclockwise with a hex
wrench. To install the pad, perform the removal proce-
dure in reverse.
CAUTION:
Make sure that the pad is secured
properly. Loose attachment will run out of balance
and cause an excessive vibration which may cause
loss of control.
Connecting a vacuum cleaner
Optional accessory
When you wish to perform operation cleanly, connect a
Makita vacuum cleaner to your tool. Connect a hose of
the vacuum cleaner to the dust nozzle using the front
cuff 24.
1
► 1 . Hose of the vacuum cleaner 2. Front cuff 24
3. Dust nozzle
1
2
3
2
3
11 ENGLISH
Installing or removing the extension
handle
Optional accessory
To install the extension handle, attach the extension
handle to the tool and secure it with the knob firmly. Be
sure to insert the end of the tool into the holder of the
extension handle. To remove the extension handle,
perform the installation procedure in reverse.
2
► 1 . Extension handle 2. Knob 3. Holder 4. End of tool
1
3
4