Makita DSL800 Instruction Manual page 10

Remove any dirt or foreign matter from the pad, and
then attach the abrasive disc to the pad while aligning
the holes in the abrasive disc with those in the pad.
Adjusting the pipe length
CAUTION:
When adjusting the pipe length,
hold the tool horizontally. Otherwise, the pipe
length may change unintentionally and it may cause
an injury or malfunction of the tool.
NOTICE:
Do not extend the pipe beyond the
limit. Failure to do so may cause a malfunction of
the tool.
1
2
► 1 . Sleeve 2. Pipe
To adjust the pipe length, loosen the sleeve, then adjust
the length of the pipe, and then tighten the sleeve.
Installing or removing the dust
collection brush
Before sanding operation, install the dust collection
brush to the sanding head as shown in the figure.
1
► 1 . Dust collection brush 2. Sanding head
You can remove the dust collection brush for operation
along the edge of wall or ceiling. The removed brush
can be attached to the sanding head as shown in the
figure.
► 1 . Dust collection brush 2. Sanding head
Hex wrench storage
► 1 . Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
2
10 ENGLISH
1
2
1