Install Brackets - Char-Broil 9538103 Product Manual

ASSEMBLY OF ROD BRACKET
1. Insert one #10-24x5/8" flat head screw (A)
into one roller bering as shown.
2. Insert the end of the flat head screw through
the rod bracket.
3. Install and tighten one #10-24 acorn nut (B).
Tighten securely with a phillips screwdriver.
4 . NOTE: You may have to reverse the side of the
bracket that you mount the roller bearing to,
depending upon the fit of the rotisserie to your
grill.

INSTALL BRACKETS

1. Place the rod bracket near the lower firebox
mouinting holes, as shown at right.
2. Insert one 10-24x1/2" screw (C) through the
bracket and through the firebox.
3. While holding hte bracket in place, thread one
10-24 KEPS nut (D) onto the screw.
4. Repeat steps 2 & 3 for the second mounting
hole.
5. Do not fully tighten the screws until you have
adjusted the rotisserie to fit your grill.
6 . NOTE: Depending on the model of grill you are
using - you may need to mount the bracket on
the inside of the firebox. This is an acceptable
mounting position.
7. You will mount the motor bracket on the oppo-
site side of the grill in the same method.
8 . NOTE: The motor bracket must be mouted on
the OUTSIDE of the firebox.
9. Depending on the configuration of your grill, you
may mount the motor bracket on either side. Be
careful, however, that you DO NOT mount the
motor next to the side burner, if equipped.
INSTALL YOUR MOTOR
1. Install the Motor onto the motor bracket by
aligning the mounting tabs with the bracket
slots.
2. Allow the motor to come to a rest at the bottom
of the slots.
GB
ROLLER BEARINGS
A
ROLLER BEARINGS
A
Alternate Assembly
C
4
B
ROD BRACKET
B
ROD BRACKET
D