Field Operation - Pelsue PH Series Product Manual

Pelsue PH Series Personnel Hoists are designed for use in many applications including but not limited to personnel
riding, rescue or confined space entry/retrieval. It is the responsibility of the operator to be familiar with and follow all
applicable OSHA and industry standards on operating guidelines for your project. If you have any questions, consult a
qualified person or call the factory.
When using the hoist, follow this procedure:
1. Review and follow the Pre-Operation Inspection (Refer to Section 5.3).
2. Inspect the unit prior to each use. Visually check each component to be sure that there is no damaged or missing
parts. Check that all systems and components function as intended. Do not use the equipment if any problems are
found.
3. Work Planning
Plan your entire work project before starting. Consider all the equipment and system requirements and comply with
these requirements before starting. Anticipate the needs before, during and after the project is being done and prepare
for these needs. Be prepared for the unexpected by planning in advance. Your advance planning list includes but is not
limited to:
a. Anchorage
We recommend mounting the hoist to other Pelsue supporting components and systems to be sure that the
anchorage has sufficient strength. Pelsue support and mounting systems are designed to ANSI and OSHA
standards. Refer to Structural Manual for specific strengths. When using other manufactures' anchorages in
conjunction with a PH Series Hoist, be sure they meet OSHA or local requirements and have capacities equiva-
lent to or greater than the hoist being used.
b. Connectors
Connectors, if used, should be equipped with an anti-rollout device to prevent accidental disengagement.
Rollout can occur when there is interference between the connector and load that causes the gate or keeper to
accidentally open or release. Do not take a chance with safety. Only use approved components.
c. Hazards
Stay away from mechanical, chemical and electrical hazards. Moving machinery, sharp edges or other mechani-
cal hazards can injure personnel, damage equipment or interfere with the work procedure. Chemical, corrosive
or toxic environments can damage equipment or affect the well being of personnel. Electrical power can flow
through the equipment and electrocute personnel even if there is no direct contact. Sparks or electricity from
welding may damage safety lines and cables. Plan your work and rescue procedures to consider these factors
and allow for them. Advance planning will allow the equipment to be used safely in a variety of conditions.
d. line Path
Body parts, clothing, tools or other items can get entangled or snagged when going around a corner or over
obstacles during the retrieval procedure. Corners or sharp edges can also damage the lifeline as it goes by.
Ensure that the hoist line does not come into contact with a heat source or hot object that may damage it. Cau-
tions must be taken when more than one person is tied off separately to prevent the lines from becoming knotted
together. Do not step across another hoist line or lifeline. Be prepared to perform a non-entry rescue to assist
in the retrieval of a down entrant.
e. Vertical Applications
For vertical applications, keep the swing-fall angle less than 30 degrees. Serious injuries to personnel can occur
if they swing into a solid object. Try to keep the entrant directly below the hoist attachment point at all times. At
least two (2) people are required at all times: the entrant and the hoist operator. Always maintain communication
to be sure the lifeline is kept taut and that the entrant is not encountering problems.
f. emergency
During rescue or emergency procedures, the hoist anchorage must be capable of supporting at least 1500 lbs.
(680 kg.). Always use an approved harness when moving people. People can be seriously injured during rescue
or in an emergency situation if they are not supported in an approved harness. However, quick response is
required in any emergency or rescue operation.
501144-001 - Product Manual - PH Series Personnel Hoists - Revison 03 Revision Date - 2018-06-13

5.5 - Field Operation

Page 15