Before Starting Machine - Taylor Tools Bronco 260P-HL Owner's Manual

Before Starting Machine:

1. Check hydraulic oil level indicator and fill
with Mobil DTE 25 or DTE 26 or equivalent if
necessary. If pumps run dry, permanent damage
may occur.
2. Check for oil leaks and repair as necessary.
3. Inspection the power source for proper circuit
breaker protection, and make sure the GFI has
been installed. This should be done by a quali-
fied person or an electrician.
4.Inspect the electrical cord for damage and
replace or repair as necessary.
5. Make sure the area is cleared of obstacles, and
personnel that do not need to be in the area for
demolition of the floor.
6. Operator and all personnel in the demolition
area must be wearing proper safety equipment.
Required safety equipment; safety glasses,
safety shoes, leather work gloves, hearing pro-
tection, hard hat, reflective outerwear.
Start Up:
a.To start the motor, the operator must be in the
seat with the seat belt restraining system prop-
erly installed, and the controls in the neutral
position.
b. Turn the key clockwise to start the motor, or
press the start switch for electric machines. The
motor will start and the machine is ready for
operation. To stop the motor turn the key coun-
terclockwise or press the stop button and the
motor will stop.
Driving:
a. To move the Bronco floor stripper forward or
reverse, depress the control levers downward
with the palm of your hands. This activates the
operator present feature and allows the levers to
move forward and backward. Keep depressing
the levers at all times when operating the ma-
chine.
O
PERATION
The right lever controls the speed and direction
of
the right wheel and the left lever controls the
speed and direction of the left wheel.
Do not use your thumbs to press the control
levers down. This will cause fatigue, and possi-
bly lock the control levers in the netural position
by mistake.