Operating Instructions - Hoshizaki DCM-60KE Instruction Manual

Cubelet ice dispenser
Hide thumbs Also See for DCM-60KE:
Table of Contents

Advertisement

ENGLISH
Water Supply
Inlet G3/4
Inlet Hose
[Connection to the drain]
* Attach the grey flexible drain hose (accessory) to the fitting at the bottom of the drain pan. Use the hose clamp (accessory) to
obtain a leak free joint.
* Drain lines should not be installed directly to the sewer system. A vertical air gap of a minimum of 5 cm should be between the
end of the drain hoses from the ice dispenser and the floor drain.
* The ice dispenser drain is gravity flow, ensure drain hose has an adequate pitch or fall.
GOOD
Downgrade
II. OPERATING INSTRUCTIONS
Do not put your hands into the dispensing outlet. The icemaking mechanism may
suddenly move, resulting in injury.
All parts are factory-adjusted. Improper adjustments may result in failure.
If the unit is turned off, wait for at least 3 minutes before restarting the ice dispenser to prevent damage to the compressor.
Periods of 5 to 6 hours without dispensing ice could result in wet ice or an ice bridge forming in the storage bin. Always
turn off the ice making switch, and remove ice from the storage bin within 2 hours. Soggy and sticky ice should be removed
continuously as produced.
This ice dispenser is programmed to suspend ice dispensing action when the push lever/dispense switch is continuously pressed
for more than 2 minutes. Also, pressing and releasing the push lever/dispense switch repeatedly for extended periods may cause
the protector to stop the ice dispenser.
This ice dispenser is designed to produce edible ice. To keep the ice dispenser hygienic, follow the instructions in "III. 1.
CLEANING".
Hose Clamp
Drain Hose
Drain Outlet
5cm air gap
Drain
BAD
Upgrade
CAUTION
NOTICE
HYGIENE
6
Water Supply Tap
Inlet Hose
BAD

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcm-60ke-pDcm-120keDcm-120ke-p

Table of Contents