Danfoss HVAC Drive FC 102 Series Instructions Manual page 13

Instructions
2.1.16 Internal Floating Point Commands (Acknowledged)
VLT Command Subcom-
Response mand
ACK 1
ACK 1
ACK 2
ACK 2
ACK 7
ACK 7
®
VLT Metasys
Region NPA Object no. Attribute No.
- 5 0-101
- 5 0-101
- 5 0-101
- 5 0-101
2 5 0-101
3 5 0-101
®
MG.11.G2.02 - VLT is a registered Danfoss trademark
Attribute Message Type
1 Byte Read Internal
Parameter of
object type float
2 Float Read Internal
Parameter of
object type float
- Float Write Internal
Parameter of
object type float
- Float Write Internal
Parameter of
object type float
- Float Override Internal
Parameter of
object type float
- - Override Release Set the current value, the
2
Comments
Read Object Status
associated with each
individual point
Read Current Value
attribute associated with
each individual point
Write to Current Value
attribute associated with
each individual point
Write to Current Value
attribute associated with
each individual point
Write to internal parame-
ter current value (set-up
parameters for VLT)
value that it was before
the 1. Override
Command was issued
13
2