Sony MAV-555SS Operation Manual page 63

Item number Display indication
768 H BLANKING WIDTH P1
769 H BLANKING WIDTH P2
770 H BLANKING WIDTH P3
BI
778 SELECTION OF VIDEO/SYNC
BI DELAY MONITOR
779 VAR CONROL P1
780 VAR CONROL P2
781 VAR CONROL P3
BI
SUB MENU
Y ADD
ESR
782 INTERNAL SIGNAL
GENERATOR R1
783 INTERNAL SINGAL
GENERATOR R2
784 INTERNAL SINGAL
GENERATOR R3
785 INPUT VIDEO BLANK R1
786 INPUT VIDEO BLANK R2
787 INPUT VIDEO BLANK R3
BI
SUB MENU
Expansion menu items (Continued)
Settings Description
These items select the horizontal blanking width for the video output signal. If
analog blanking was selected, the horizontal blanking width conforms with the
RS170A. The wider the blanking width, the narrower the picture is.
narrow : Digital blanking (narrow)
wide : Analog blanking (wide)
Selects the video output phase that is set for PB/EE on the 013 Setup menu.
VIDEO DELAY : Ignores video signal delays and adds the same sync as the output ref
to the video output. In this case, the picture moves downward when
in EE mode.
SYNC DELAY : Adds a sync signal that is offset to match the video signal delay.
These items set up the video process.
This item specifies whether to forcibly turn Y ADD off in a playback mode other than
normal playback mode (JOG, VAR, SHUTTLE, STILL, etc.).
auto : Perform Y ADD automatically in any playback mode other than normal
playback mode.
off : Forcibly turn Y ADD off in any playback mode other than normal
playback mode.
When recording or playing back a composite signal, this item specifies whether to
automatically turn the edge subcarrier reducer on/off in accordance with the playback
mode, or to force the edge subcarrier reducer on (in order to play back a non-standard
signal).
auto : Turn the edge subcarrier reducer on/off in accordance with the playback
mode.
on : Force the edge subcarrier reducer on.
These items select the test signal that is output from the internal signal generator.
When off:
No test signal is generated, and the unit operates normally.
When not off:
If an INPUT SELECT switch is held down for at least three seconds while lit, all INPUT
SELECT switches light and the internal signal generator operates. The selected test
signal is input to the REC port. It is also possible to record this signal.
off : No test signal is generated.
CB100 : 100% color bar signal
CB75 : 75% color bar signal
CB75R : 75% color bar (reverse) signal
BOW : Bowtie signal
PLSBR : Pulse and bar signal
MLTBS : Multi-burst signal
HSWP : HSWP signal (available only in 525 mode)
5STEP : 5-step signal
RAMP : Ramp signal
SH : Shallow ramp signal
RED : Full red signal
GRAY : 50% flat signal
WHITE : 100% flat signal
BB : Black burst signal
SDI : SDI check field signal
NTC7 : NTC7 test signal (available only in 525 mode)
LN330 : Line 330 test signal (available only in 525 mode)
These items turn blanking during the input video signal vertical blanking interval
on and off.
3-37 (E)
3-4 Setup