Step 2 : Setting Up The Remote Commander - Sony SLV-D201P Operating Instructions (primary manual) Operating Instructions Manual

Step 2 : Setting up the remote commander

Inserting the batteries
Insert two size AA (R6) batteries
by matching the + and – on the
batteries to the diagram inside the
battery compartment.
Insert the negative (–) end first,
then push in and down until the
positive (+) end clicks into
position.
Using the remote
commander
You can use this remote
commander to operate this DVD-
VCR and a Sony TV. Buttons on
the remote commander marked
with an orange dot (•) can be used
to operate your Sony TV.
If the TV does not have the
symbol near the remote sensor, this
remote commander will not
operate the TV.
To operate
the DVD player
the VCR
a Sony TV
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove the batteries
to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not use different types of batteries.
• Do not leave the remote commander in an extremely hot or humid place.
• Do not drop any foreign object into the remote casing, particularly when replacing the batteries.
• Do not expose the remote sensor to direct light from the sun or lighting apparatus. Doing so
may cause a malfunction.
DVD·VIDEO
SELECT VIDEO
SELECT DVD
Set TV / DVD·VIDEO to
DVD·VIDEO, then press SELECT DVD and point at the remote sensor at
the DVD-VCR
DVD·VIDEO, then press SELECT VIDEO and point at the remote sensor
at the DVD-VCR
TV and point at the remote sensor at the TV
Remote sensor
TV /
Setting up the remote commander
continued
9