Related Manuals for Schmalz EVE-KL
Summary of Contents for Schmalz EVE-KL
- Page 1 Innovative Vacuum for Automation Operating Instructions EVE -KL 30.30.01.00867/00 | 04.2015...
-
Page 2: Table Of Contents
Table of Contents Preface Preface ................... 2 Congratulations on your purchase of the Schmalz vacuum pump. Product Description ..............3 With watchful observation of the field’s requirements, innovation and Use ..................... 3 steady development Schmalz delivers modern vacuum and Principle of Operation ..............3 pressure solutions worldwide. -
Page 3: Product Description
Principle of Operation ➔ Conveying Condensable Vapours). Conveyance of other vapours shall be agreed upon with Schmalz. Conveyance of The vacuum pump works on the claw principle. water or other liquids in liquid phase increases the power The components are dimensioned such, that on the one hand there... -
Page 4: Cooling
Remove the bolting between the vacuum pump and the ♦ operating instructions shall be read and understood. If anything pallet/base plate remains to be clarified please contact your Schmalz In case the vacuum pump is fastened to the pallet by means of representative! tightening straps:... -
Page 5: Storage
However, VCI-products may attack the surfaces of plastics and − ambient pressure: atmospheric elastomers. Seek advice from your local packaging dealer! Schmalz • uses CORTEC VCI 126 R film for the overseas packaging of large Make sure that the environmental conditions comply with the protection class of the drive motor (according to the nameplate) equipment. -
Page 6: Suction Connection
In case the length of the discharge line exceeds 2 m it is prudent to CAUTION use larger line sizes in order to avoid a loss of efficiency and an overload of the vacuum pump. Seek advice from your Schmalz Intruding foreign objects or liquids can destroy the vacuum representative! pump. -
Page 7: Mounting
• Push the hub (III) onto the motor shaft such that the mounting face of the hub (III) will be located 16±1 mm before the Connection Scheme Three-Phase Motor mounting face of the NEMA-adaptor flange (I) (➔ sketch) Delta connection (low voltage): •... -
Page 8: Connecting Lines/Pipes
♦ ➔ arrow (c) (stuck on or cast) Conveying Condensable Vapours). Conveyance of other vapours shall be agreed upon with Schmalz . Conveyance of “Bump” the drive motor ♦ water or other liquids in liquid phase increases the power Watch the fan wheel of the drive motor and determine the consumption and shall therefore be avoided (risk of drive ♦... -
Page 9: Conveying Condensables Vapours
If the level does fall, the gear is leaky and the Open the ambient air valve ♦ vacuum pump requires repair (Schmalz service). Operate the vacuum pump for another approx. 10 minutes ♦ Every 6 Months: Close the ambient air valve ♦... -
Page 10: Every Year
6 Years: shall be done by Schmalz service. Note: The change interval of 20000 operating hours is valid for Schmalz approved gear oils only. The change interval depends very much on the operating conditions. Borderline operation may reduce DANGER the change interval down to approximately 5000 operating hours or 6 months. - Page 11 • Dispose of the used oil in compliance with applicable regulations • Dispose of the vacuum pump as scrap metal EVE-KL Removal from Service 30.30.01.0086 7 -00_ EN / 04.2015 Seite 11...
-
Page 12: Troubleshooting
(o, 714) as required and reassemble Repair the vacuum pump ( Schmalz service) Internal parts are worn or damaged The gas conveyed by the vacuum pump Process components evaporating under... - Page 13 Replace the coupling element Low oil level in the synchronising gear The synchronising gear is leaky R epair the vacuum pump ( Schmalz service) Repair the vacuum pump ( Schmalz service) Synchronising gear damaged due to operation with low oil level...
- Page 14 Provide a more stable power supply range Partial clogging of filters or screens Remove the clogging Partial clogging in the suction, discharge or pressure line Long suction, discharge or pressure line with Use larger diameter too small diameter EVE-KL Troubleshooting Seite 14 30.30.01.00867-00_EN / 04.2015...
-
Page 15: Sectional Drawing
Sectional Drawing EVE -KL Sectional Drawing 30.30.01.0086 7 -00_ EN / 04.2015 Seite 1 5... -
Page 16: Spare Parts
(“Type”) and the serial no. Screen 0534 000 041 (“No”) of the vacuum pump. This will allow Schmalz service to check if the vacuum pump is compatible with a modified or improved part. Filter cartridge, paper, for inlet... -
Page 17: Ec-Declaration Of Conformity
EVE-KL EC-Declaration of Conformity 30.30.01.0086 7 -00_ EN / 04.2015 Seite 17... -
Page 18: Technical Data
50/60 max. MM 1320 AV 150* ~310 600- max. MM 1320 AV 200* 4200** *to be limited by means of process control and/or vacuum relief valves **see nameplate of the vacuum pump EVE-KL Technical Data Seite 18 30.30.01.00867-00_EN / 04.2015... - Page 19 EVE-KL blank page 30.30.01.0086 7 -00_ EN / 04.2015 Seite 19...
-
Page 20: Schmalz - World Of Vacuum Tecnologie
© J. Schmalz GmbH, Fehler! Verweisquelle konnte nicht gefunden werden. This document is protected by copyright. J. Schmalz GmbH retains the rights established thereby. Reproduction of the contents, in full or in part, is only permitted within the limits of the legal provisions of copyright law. Any modifications to or abridgments of the document are prohibited without explicit written agreement from J.