Specifications - ABB TB404 Operating Instruction

INTRODUCTION
Position 1 2 3 4 5 6 7
Type T B 4 0 4
Previous Page
NOTES:
1. Temperature compensator is required when using the sensor with ABB instrumentation.
2. If hot tap hardware and compression fittings are ordered, and Kalrez O-rings are desired, position 8 must be a 4.
3. Positions 9 and 10 require 00 when ordering replacement sensors or Type TB4043 sanitary sensors.
4. An insertion length must be specified in position 11 for all sensors having L1, L2, L3 or L4 in positions 9 and 10. The type of material
selected in position 11 must match the material selected in positions 9 and 10.
5. Stainless steel 1-½-in. full port ball valves are available from ABB. Refer to Table 1-4.
6. An interconnecting cable going from the sensor to the conductivity instrument is available for a per foot charge. Refer to Table 1-4.
7. The tri-clamp gasket is not provided and must be supplied by the customer.

SPECIFICATIONS

SPECIFICATIONS
1 - 4
Table 1-2. Nomenclature
8 9 10 11 12 13
Low Pressure Hot Tap Insertion Rod
0 None or sanitary (required for TB4043)
1 50.8 cm (20.0 in.), 316 stainless steel
2 61.0 cm (24.0 in.), 316 stainless steel
3 76.2 cm (30.0 in.), 316 stainless steel
4 91.4 cm (36.0 in.), 316 stainless steel
5 50.8 cm (20.0 in.), Titanium
6 61.0 cm (24.0 in.), Titanium
7 76.2 cm (30.0 in.), Titanium
8 91.4 cm (36.0 in.), Titanium
Cable Length
1 1.5 m (5.0 ft)
2 3.0 m (10.0 ft)
3 4.6 m (15.0 ft)
4 6.1 m (20.0 ft)
5 9.1 m (30.0 ft)
6 12.2 m (40.0 ft)
7 15.2 m (50.0 ft)
Identification Tag
0 None
®
1 Mylar
2 Stainless steel
Table 1-3 lists the specifications for the Type TB404 sensors.
(continued)
Toroidal Conductivity Sensor
4
6