Channel And Clock Settings (General) - Sony RDR-GX380 Operating Instructions Manual

Channel and Clock Settings
(General)
The [General] setup helps you to make channel,
clock, and other settings for the recorder.
Select [General] in the Setup Display. To use
the display, see "Using the Setup Displays" (page
65).
The default settings are underlined.
Auto Channel Setting
Manual CH Setting
Clock Setting
TV Type
LINE 3 In
Video output format
Power Save
Factory Set
[Auto Channel Setting]
Presets all receivable channels automatically.
Select your country. Then select [Start] and press
ENTER.
[Manual CH Setting]
Presets channels manually.
If some channels could not be set using the Auto
Channel Setting function, you can set them
manually.
If there is no sound or if the picture is distorted, the
wrong tuner system may have been preset during
[Auto Channel Setting]. Set the correct tuner
system manually in the steps below.
1
Select [Manual CH Setting] and press ,.
Auto Channel Setting
Manual CH Setting
Clock Setting
TV Type
LINE 3 In
Video output format
Power Save
Factory Set
66
2
3
France
Start
4
Set
b
Be sure to correctly select the programme position you
want to disable. If you disable the wrong programme
position by mistake, you need to reset that channel
manually.
Press ENTER while [Set] is selected.
The Channel List menu appears.
PR
01
02
03
04
05
PR-01 NICAM
06
07
08
09
10
11
Press M/m to select the programme position
you want to set, and press ENTER.
PR
01
02
03
04
05
PR-01 NICAM
06
Manual CH Setting
07
Name
08
Move
09
Erase
10
Decoder On/Off
NICAM/Standard 11
Select an option from the sub-menu, and press
ENTER.
[Manual CH Setting]: Sets the channel
manually. See "To set the channels manually"
(page 67).
[Name]: Changes the station name. The
display for entering characters appears. To
enter characters, see page 33.
[Move]: Sorts the programme positions on the
Channel List. Press M/m to move the selected
programme position to a new location.
[Erase]: Disables a programme position you
do not need.
[Decoder On/Off]: Sets the channels for the
decoder. You need this setting to watch or
record PAY-TV/Canal Plus programmes.
Press ENTER so [Decoder] appears on the
display. Press ENTER again to turn off the
setting.
[NICAM/Standard]: Sets the channels for the
NICAM broadcast. Normally, [NICAM] is lit
on the display. If the sound from NICAM
broadcast is not clear, press ENTER so
[NICAM] disappears.
Note
Ch. Fine Station
C 12 0 AWB1
C 23 0 AWB2
C 7 0 DTV
C 27 0 CH2
C 17 0 LHTV
C 33 0 CSN
C 34 0 PTGLE
C 47 0 PSG
C 10 0 TV2
Ch. Fine Station
C 12 0 AWB1
C 23 0 AWB2
C 7 0 DTV
C 27 0 CH2
C 17 0 LHTV
C 33 0 CSN
C 34 0 PTGLE
C 47 0 PSG
C 10 0 TV2