Sony RDR-GX380 Operating Instructions Manual page 14

A SCART input jack
When setting [Video output format] to [RGB] in
the [General] setup (page 68), use a SCART cord
that conforms to the selected signal.
B Component video input jacks (Y, P
C )
R
You will enjoy accurate colour reproduction and
high quality images.
If your TV accepts progressive 576p format
signal, use this connection and set the
RESOLUTION button on the front panel to
"576p" (page 9). Then set [Video output format]
to [YP P ] in the [General] setup to send
B R
progressive video signals (page 68).
C HDMI input jack
Use a certified HDMI cord (not supplied) to enjoy
high quality digital picture and sound through the
HDMI OUT jack. Then while watching the
pictures, adjust the video output resolution by
pressing the RESOLUTION button on the
recorder. The indicator on the front panel display
changes with each press:
576i t 576p t 720p
R
1080p T
To see the signals from the connected set top box
receiver when the set top box receiver is
connected to the recorder using a SCART cord
only, turn the recorder on.
14
R
1080i
When connecting to the HDMI OUT jack
Follow the steps below. Improper handling may
damage the HDMI OUT jack and the connector.
1
Carefully align the HDMI OUT jack on the
rear of the recorder and the HDMI connector
/C , P /
B B R
by checking their shapes.
Make sure the connector is not upside down or
tilted.
M I
H D
Connector is upside
down
2
Insert the HDMI connector straight into the
HDMI OUT jack.
Do not bend or apply pressure to the HDMI
connector.
b
Notes
• Be sure to disconnect the HDMI cord when moving the
recorder.
• Do not apply too much pressure to the cabinet wall, if
you place the recorder on the cabinet with the HDMI
cord connected. It may damage the HDMI OUT jack or
the HDMI cord.
• Do not twist the HDMI connector while connecting to
or disconnecting from the HDMI OUT jack to avoid
damaging the HDMI OUT jack and connector.
When playing "wide screen" images
Some recorded images may not fit your TV
screen. To change the picture size, see page 68.
If you are connecting to a VCR
Connect your VCR to the LINE 3/DECODER
jack on the recorder (page 22).
T
O U
M I
H D
Not straight
T
O U
M I
H D
T
O U