Nand Flash_Scb0 - Waveshare Open407V-C Testing Manual

www.waveshare.com
Overview
Nand Flash_SCB0 demo
Hardware Connection
·
Connect the NandFlash Board (A) (K9F1G08U0D SCB0 onboard) to the board via 8BIT FSMC interface.
·
Connect the serial port converter to the board via UART3. As shown in the figure below:
Operation and Result
Launch the serial debugging assistant, and configure it as described in chapter "Preparation".
Info/message will be displayed on the serial debugging assistant.

Nand Flash_SCB0

14
Open407V-C\Open207V-C Testing Guide