Nand Flash_Pcb0 - Waveshare Open407V-C Testing Manual

www.waveshare.com
Overview
Nand Flash_PCB0 demo
Hardware Connection
·
Connect the K9F1G08U0C NandFlash Board (K9F1G08U0C PCB0 onboard) to the board via 8BIT FSMC
interface.
·
Connect the serial port converter to the board via UART3. As shown in the figure below:
Operation and Result
Launch the serial debugging assistant, and configure it as described in chapter "Preparation".
Info/message will be displayed on the serial debugging assistant.

Nand Flash_PCB0

13
Open407V-C\Open207V-C Testing Guide