Control Panel Information - Genie GCL OPGSX Series Installation Manual

Control Panel
Fire Door Operators include a full function control panel including a liquid crystal display (LCD), calibration keys and Open, Close and
Stop keys for on board operator control. See Fig. 1. The open, close and stop keys function as a 3-button wall control. The Display will
show current operator conditions and calibration information. Due to limited character space, some displays will be abbreviated.
Operators include a non-volatile memory. The unit will remember all calibration settings plus error code and run code logs, if power is
removed from unit.
DANGER:
!
After power is supplied to the operator, Do Not make contact with components inside the control panel
except for the Keypad Keys. Fig. 1.
DANGER:
!
Après avoir mis l'opérateur sous tension, NE PAS entrer en contact avec des composants à l'intérieur du
panneau de commande, sauf pour les touches du pavé numérique. Fig. 1.
WARNING:
!
DO NOT calibrate operator or operate door unless doorway is in sight and free obstructions. Door will
move during setup. Keep people clear of opening while door is moving.
AVERTISSEMENT:
!
obstacle.
La porte se déplacera pendant la programmation. Ne laisser personne
se tenir dans l'ouverture de la porte pendant qu'elle est en mouvement.
AFTER WIRING HAS BEEN COMPLETED, APPLY POWER TO THE OPERATOR.
Control Operating Modes
Operator control boards operate in two modes: Run Mode and Calibration Mode. The control board should
normally operate in the Run Mode.
With the operator standing idle:
Press CAL/RUN key to toggle between operating modes.
• The first display in CALIBRATION mode is "SET CLOSE DIR . "
• The display in RUN mode will be one of the condition codes listed in section 8.
Calibration & Run Key.
Section 6: Operator Setup Procedure
Calibrer l'opérateur et utiliser la porte uniquement si la porte est en vue et libre de tout
Alarm will sound and beep once every 10 seconds.
Display will read "SET CLOSE DIRECTION"
FIGURE 1
LCD DISPLAY
Display Backlighting Toggle Key.
CAL SET
SCROLL
RUN
CLEAR
SCROLL
Scroll Keys, used in Calibration Mode.
Operation Keys,
operate unit like
a 3-button wall
station.
OPEN
CLOSE
STOP
Set/Clear Key,
used to reset and
adjust calibration
settings.
6.1