Monitored Reversing Devices - Genie GCL OPGSX Series Installation Manual

Monitored Reversing Devices

1) Press SET/CLEAR key to toggle to "ODC STB > ON".
2) Press SCROLL UP until display reads "OPEN MODE > C-STOP".
3) Press CAL/RUN to return to run mode.
NOTE: STB photocells should NOT be used on the Fire Door Operator. Use only Monitored Safety Edges listed:
1). MillerEdge ME and MT series monitored edge sensors used in combination with MillerEdge Interface
Module OPAKMEIX.S. (Direct connect through STB inputs.)
2). MillerEdge Wireless monitored edge sensor OPAKMMWE.S.
Section 6: Operator Setup Procedure
Figure 16
ODC STB ON
CAL SET
SCROLL
RUN CLEAR
SCROLL
OPEN
CLOSE
STOP
6.7