Safety Precautions; Tips - Hugyfot Vision Xs User Manual

2. Safety precautions

To prevent personal injury and/or damage to equipment, read this User
Manual carefully, as well as your GoPro Hero 5/6/7 owner's manual, and other
accessories used in combination with your Hugyfot Vision Xs housing.
To prevent personal injury:
- Only use battery packs specified in this User Manual and follow
manufacturer's instructions.
- Remove leaking battery packs immediately from your Hugyfot Vision Xs.
Leaking occurrences are extremely rare. Handling a defective battery
pack must be done with care, avoiding exposure to bare skin, inhaling gas
emissions or contact with fluids that could leak from a defective battery
pack.
-
Keep battery packs away from children.
- Dive within your level of training, maintain awareness of your depth, tank
pressure and decompression limits at all times.
- Your Hugyfot Vision Xs underwater housing is designed to withstand
depths of up to 490 feet (150 meters), well beyond recreational dive
limits, as well as most technical dive depths. Stay within safety dive limits
in keeping with your level of certification and expertise. Do not use your
Hugyfot Vision Xs housing at depths beyond your training level and skills.
To prevent equipment damage:
- Never leave your Hugyfot Vision Xs housing in direct sunlight as heat
buildup may exceed recommended temperature ranges, causing
permanent damage to electronic components, including your camera.
- Your Hugyfot Vision Xs housing is designed to operate between 32°F and
86°F (0°C and 30°C).
- Do not use paint thinners, benzene nor harsh solvents to clean your
Hugyfot Vision Xs housing, as these products will damage the finish of
your housing, can cause fire and are harmful to your health.
Hugyfot User Manual Vision Xs

3. Tips

- Your Hugyfot Vision Xs housing is developed and machined with great
precision. Treat it with care. Avoid dropping or exposing to impacts.
-
The inside of your Hugyfot Vision Xs housing is not waterproof and must be
kept dry at all times. Avoid water droplets from entering your housing. In
the event salt water enters your housing, pad it dry immediately using an
absorbent towel. Use a damp cloth to remove any salt crystals.
- Ambient humidity and temperature differentials may cause condensation
inside your Hugyfot Vision Xs housing, particularly when moving it from
cold to warm environments. Avoid condensation by keeping your housing
in a sealed bag or an airtight case. Allow your housing to acclimate, then
remove it from the bag or case. To reduce risk of condensation, do not
open your housing between dives.
- If condensation forms inside your Hugyfot Vision Xs housing, do not
use it. Open your housing, remove the camera, battery packs and allow
condensation to completely evaporate before using it.
- Following any extended period of storage, check that your Hugyfot Vision
Xs housing is operating properly before diving.
- Thoroughly rinse your Hugyfot Vision Xs housing in fresh water after each
dive. Repeatedly push all buttons and levers while submerged to purge
trapped water and flush internal spring mechanisms.
- Your Hugyfot Vision Xs housing has two (2) O-rings. Carefully inspect,
service and lubricate each O-ring before diving.
Hugyfot recommends having your Vision Xs housing serviced every 2 years, at a
minimum, by an authorized Hugyfot dealer.
4