Canon PIXMA TS8200 Series Getting Started page 4

Setting up the printer
2
Remove the tape and film on the ink tanks.
b
•
Check that no tape is left over.
3
Slowly remove the orange cap.
Important
•
Do not push both sides of the ink tank
with the Y-shape air hole blocked.
•
Do not touch the red areas shown in the
figure.
4
Install the ink tanks.
•
Insert the ink tank into the print head and press it
from above until it clicks.
5
Make sure that the color of the ink tank you
installed appears on the screen.
Important
If the color is not displayed on the screen even though you
have installed the ink tank, the color of the ink tank may be
wrong or you may have installed an ink tank, such as one
with a different model number, that is not supported by this
printer. Either install an ink tank for the correct color or use the
provided ink tank for setup.
2
TS8200_GS_book.indb 2
a
6
Repeat steps 2 through 5 to install all the ink
tanks.
•
Make sure that all the colors appear.
7
Close the scanning unit / cover.
•
When you close the scanning unit / cover, the
internal operations start.
a
b
Watch your fingers.
5. Loading Paper
Check!
If there is any orange tape, remove
it.
1
Tap OK.
2
Pull the cassette out of the device and remove
the cassette cover.
Cassette cover
b
a
Caution
30/03/2018 10:30:27