Lancia Fulvia Coupe Instruction Book page 56

FUNCTIONAL ROUTINE MAINTENANCE
Lubrication
Engine oil sump
Cooling System
Adjusting the fan and dyna-
mo driving belts
Whenever such conditions do not occur, without
removing the distributor from its seat, loosen
the nut securing the fastening bracket a nd slightly
turn the distributor body to the right or to the
left, secure it and then repeat the above checking.
Every 14,000 km (8,700 miles)
clean the
strainer.
To carry out this operation, remove the engine
sump then take off the strainer.
Every 7,000 km (4,350 miles)
check the belts
for tension; if necessary, adjust them.
To adjust the dynamo belt, first loosen the
fan belt by acting on screws (2) and on toothed
sector (3), rotating it inwards, then loosen nut (I)
and displace the dynamo upwards. To adjust
the fan belt, loosen screws (2), and act on the
toothed sector (3), rotating it outwards. The
tension is correct when the thumb pressure pushes
the belts down by about 5 to 10 rnm (0.196 to
0.393 in.).
Adjust; ng the fan and
dynamo driving belts