Advertisement
Check list for common problems:
S/N
Troubles
When the general supply
at the back of the host
machine is turned on, the
1
power indicator is off and
pressing "POWER" does not
work.
When the general supply is
turned on, the light works,
but when the host machine
2
is moved, the light glints and
the machine cannot be
turned on normally.
After the host machine is set
well and starting output, the
3
chosen hand piece does
not work.
Output indicator works and
the host machine outputs
4
normally, but accessory
probe does not work.
To change protective tube:
Disconnect the power of the host machine fi rst. The cover of protective tube
shall be unscrewed by a screwdriver. Check the protective tube inside the
protective tube case near to the power supply socket of the host machine,
and change it with a new 250V/4A protective tube if it is damaged.
1. Electric outlet
Pelactiv Ultrasonic System
Causes
The host machine
has not been
electrifi ed.
Power input does
not touch well
The probe is
not connected
with the
corresponding
output port.
1.
Accessory
probe is
broken.
2. Output of the
host machine
fails.
2. Protective tube
21
Remedies
1.
To check the condition of the
power cord.
2.
To check the power cord of
power supply is well plugged
in.
1.
To check the plug of the
power cord of power supply
to see if it is connected well.
2.
Whether the power cord of
power supply is broken or not.
To choose the corresponding
output port by pressing "SELECT" to
start the probe.
To test by plugging working probe
into corresponding output port
("SELECT" shall be corresponding
with output port.). To regulate the
energy to Shift 5, but not over Shift
5. If the probe works, it means the
accessory is broken; otherwise, the
host machine fails.
3.The cover of protective tube
Settlements
1.
To change the power
cord if necessary.
2.
To plug the power cord
supply again.
1.
Poor connection: to plug
the connecting plug
between the host ma-
chine and electric outlet
again.
2.
If the power cord of
power supply is broken,
related parts shall be
changed in specifi c
maintenance center
nearby.
To plug the probe in the cor-
responding output port.
1.
To change the broken
accessories.
2.
To send the host ma-
chine to specifi c mainte-
nance center to repair.
Advertisement
