Connect 1&1 Homeserver - 1&1 Homeserver+ Quick Start Manual

1. Connect 1&1 HomeServer
Step 1
Plug in the 1&1 HomeServer to a power
socket using the power supply cable.
The "Power / DSL" light will start to flash
after a few seconds.
Step 2
Plug the long end of the DSL cable into
the port labelled "DSL" on your
1&1 HomeServer.
Step 3
Plug the other end of the DSL cable into the
port labelled "F" on the telephone socket.
Step 4
The "Power / DSL" light will stop flashing
and will be permanently illuminated once
the connection to the DSL network has been
established. This may take a few minutes.
FO N
FO N
F O N F O N
FO N FO N
F O N
F O N
There will be no DSL connection until your DSL
connection date. The connection will be available by
6pm at the latest on this day. 1&1 will inform you of
your connection date by letter, email and SMS.
Note:
Only use the original po-
wer supply delivered with
this 1&1 HomeServer!
Note:
– Phone socket –
Only connect the 1&1
HomeServer to the master
telephone socket! Ask a
or technician to remove all
other telephone sockets
where possible, as these
– Black cable end
may interfere with the
remains unused! –
signal and affect your
connection.
11