Reset 1&1 Homeserver To Factory Settings - 1&1 Homeserver+ Quick Start Manual

Reset 1&1 HomeServer to factory settings
Step 1
Click on System > Sicherung
Security) in the 1&1 HomeServer menu.
1
Step 2
Click on Werkseinstellungen
settings) .
2
Step 3
Click on Werkseinstellungen laden
(Restore factory settings) .
3
Step 4
Click on OK .
4
Step 5
Confirm your selection. To do this, enter
the code sent to your telephone or press a
button on your 1&1 DSL router.
Step 6
OK
Click on to confirm that you wish to
restore the factory settings.
(System >
(Factory
1
The 1&1 HomeServer will now be reset. This may take
a few minutes. Your 1&1 HomeServer automatically
restarts and must then be set up again using the
1&1 Start-Code.
2
3
4
Save settings
By restoring factory set-
tings, all settings, telepho-
ne books, dial options etc.
will be deleted. As such, it
is important to save your
settings and telephone
books before restoring the
1&1 HomeServer.
Completing the
factory settings
Do not under any circum-
stances unplug the device
from the power socket - it
can damage the firmware.
The 1&1 HomeServer is
ready for use as soon as
the Power / DSL LED is
permanently illuminated.
29