Settings For The Speakers (Speaker Setup) - Sony DVP-NC685V Operating Instructions Manual

Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound,
set the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume and the balance of the
speakers to the same level.
This setting is effective when connecting the
speaker with 5.1 CH OUTPUT jacks (page
24).
You can create two different Speaker Setup
settings, one for Super Audio CDs and one for
all other types of discs.
1
Follow steps 1 through 4 of "Using
the setup display" (page 70) to
select "SPEAKER SETUP" in the
Setup display.
SPEAKER SETUP
DVD:
SUPER AUDIO CD:
2
Select "DVD" or "SUPER AUDIO
CD" using X/x, then press ENTER.
Example: when "DVD" is selected.
SPEAKER SETUP (DVD)
SIZE:
DISTANCE:
LEVEL(FRONT) :
LEVEL(REAR) :
TEST TONE:
FRONT:
CENTER:
REAR:
SUBWOOFER:
3
Set the following items in the
order that they are explained
below.
The default settings are underlined.
OFF
LARGE
LARGE
LARGE(REAR)
YES
To return to the default setting
Select the item, then press CLEAR. Note that
only the "SIZE" setting does not return to the
default setting.
SIZE
Selects the size of the speakers.
• FRONT
LARGE
Normally select this position.
SMALL
Select this when the speaker
cannot reproduce adequate bass
frequencies.
• CENTER
LARGE Normally select this position.
SMALL Select this when the speaker
cannot reproduce adequate bass
frequencies.
NONE
Select this if you do not connect
a center speaker.
• REAR
LARGE Normally select this position.
(REAR/
Select according to the rear
SIDE)
speaker position*.
SMALL
Select this when the sound
(REAR/ distorts or the surround effects
SIDE)
are difficult to hear.
Select according to the rear
speaker position*.
NONE
Select this if you do not connect
rear speakers.
* Rear speaker position
Correctly specify the location of the rear speakers to
enjoy the surround effect.
• Set to "SIDE," if the location of the rear speakers
corresponds to section A below.
• Set to "REAR," if the location of the rear speakers
corresponds to section B below.
This setting affects only "VIRTUAL REAR
SHIFT," "VIRTUAL MULTI REAR," and
"VIRTUAL MULTI DIMENSION" mode (page
55).
77
c continued