Settings For The Sound (Audio Setup) - Sony DVP-NC685V Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 70).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the
following jacks:
– LINE OUT L/R (AUDIO) 1/2 jacks
– 5.1CH OUTPUT jacks
OFF
Normally, select this position.
ON
Select this when the playback sound
from the speakers is distorted.
AUDIO DRC (Dynamic Range Control)
(DVD only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC." This affects the
output from the following jacks:
– LINE OUT L/R (AUDIO) 1/2 jacks
– 5.1CH OUTPUT jacks
– DIGITAL OUT (OPTICAL or COAXIAL)
jack only when "DOLBY DIGITAL" is set
to "D-PCM" (page 76).
STANDARD Normally select this position.
TV MODE Makes the low sounds clear
even if you turn the volume
down.
WIDE
Gives you the feeling of being
RANGE at a live performance.
Selects the digital filter to reduce noise above
22.05 kHz (Sampling frequency (Fs) of the
audio source is 44.1 kHz), 24 kHz (Fs is 48
kHz), or 48 kHz (Fs is above 96 kHz).
SHARP
SLOW
There may be little effect by changing the digital
filter depending on discs or playback environment.
OFF
STANDARD
SHARP
DOLBY SURROUND
Switches the method for mixing down to 2
ON
channels when you play a DVD which has
D-PCM
D-PCM
rear sound elements (channels) or is recorded
48kHz/16bit
in Dolby Digital format. For details on the
rear signal components, see "Displaying the
audio information of the disc" (page 54). This
function affects the output of the following
jacks:
– LINE OUT L/R (AUDIO) 1/2 jacks
– DIGITAL OUT (OPTICAL or COAXIAL)
DOLBY
SUR-
ROUND
NORMAL
Select this if audio signals are to be output via
the DIGITAL OUT (OPTICAL or
COAXIAL) jack.
ON
OFF
Super Audio CD audio signals are not output from
a digital jack.
AUDIO FILTER (except Super Audio CD)
Provides a wide frequency
range and spatial feeling.
Provides smooth and warm
sound.
Note
DOWNMIX (DVD only)
jack when "DOLBY DIGITAL" and "DTS"
is set to "D-PCM" (page 76).
Normally select this position.
Multi-channel audio signals are
output to two channels for
enjoying surround sounds.
Multi-channel audio signals are
downmixed to two channels for
use with your stereo.
DIGITAL OUT
Normally select this position. When
you select "ON," see "To set the digital
output signal" for further settings.
The influence of the digital circuit
upon the analog circuit is minimal.
Note
75
c continued