Sony DVP-NC625 Primary Operating Instructions Manual page 24

8
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your amplifier
(receiver) appears.
Is this player connected to an amplifier
(receiver) ? Select the type of jack you
are using.
YES
9
Press X/x to select the type of jack
(if any) you are using to connect to
an amplifier (receiver), then press
ENTER.
Choose the item that matches the audio
connection you selected on pages 19 to
22 (
A
A
• If you connect just a TV and nothing
else, select "NO." Quick Setup is
finished and connections are complete.
B-1 C-1
• Select "LINE OUTPUT L/R
(AUDIO)." Quick Setup is finished and
connections are complete.
B-2 C-2
• Select "DIGITAL OUTPUT." The
Setup Display for "DOLBY DIGITAL"
appears.
10
Press X/x to select the type of
Dolby Digital signal you wish to
send to your amplifier (receiver).
Choose the signal that matches the audio
connection you selected on pages 20 to
22 (
B
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
24
LINE OUTPUT L/R (AUDIO)
DIGITAL OUTPUT
NO
through ).
D
D
through ).
D
STANDARD
DOLBY SURROUND
DOLBY DIGITAL
11
12
13
OFF
ON
D-PCM
D-PCM
B-2 C-2
• D-PCM (page 66)
D
• DOLBY DIGITAL (only if the
amplifier (receiver) has a Dolby Digital
decoder) (page 66)
Press ENTER.
"DTS" is selected.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
Choose the item that matches the audio
connection you selected on pages 20 to
22 ( through
B
B-2 C-2
• OFF (page 66)
D
• ON (only if the amplifier (receiver) has
a DTS decoder) (page 66)
Press ENTER.
Quick Setup is finished. All connections
and setup operations are complete.
If your AV amplifier (receiver) has an
MPEG audio decoder, set "MPEG" to
"MPEG" (page 66).
OFF
STANDARD
DOLBY SURROUND
ON
D-PCM
PCM
OFF
OFF
ON
).
D