Omega OMB-DAQ-54 User Manual page 167

API Error Codes
DerrTooManyHandles
DerrInvLockMask
DerrAlreadyLocked
DerrAcqArmed
DerrParamConflict
DerrInvMode
DerrInvOpenMode
DerrFileOpenError
DerrFileWriteError
DerrFileReadError
DerrInvClockSource
DerrInvEvent
DerrTimeout
DerrInitFailure
DerrBufTooSmall
DerrInvType
DerrArraySize
DerrBadAlias
DerrInvCommand
DerrInvHandle
DerrNoTransferActive
DerrNoAcqActive
DerrInvOpstr
DerrDspCommFailure
DerrEepromCommFailure
DerrInvEnhTrig
DerrInvCalConstant
DerrInvErrorCode
DerrInvAdcRange
DerrInvCalTableType
DerrInvCalInput
DerrInvRawDataFormat
DerrNotImplemented
DerrInvDioDeviceType
DerrInvPostDataFormat
DerrdaqStalled
DerrdaqLostPower
DerrdaqMissing
DerrdaqScanConfig
B-34 API Commands
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
60h - 96 No more handles available to open
61h - 97 Only a part of the resource is already locked, must be all or none
62h - 98
All or part of the resource was locked by another application
63h - 99 Operation not available while an acquisition is armed
64h - 100
Each parameter is valid, but the combination is invalid
65h - 101 Invalid acquisition/wait/dac mode
66h - 102 Invalid file-open mode
67h - 103 Unable to open file
68h - 104 Unable to write file
69h - 105 Unable to read file
6Ah - 106 Invalid acquisition mode
6Bh - 107 Invalid transfer event
6Ch - 108 Time-out on wait
6Dh - 109 Unexpected result occurred while initializing the hardware
6Eh - 110 Unexpected result occurred while initializing the hardware
6Fh - 111 Invalid acquisition/wait/dac mode
70h - 112 Used as a catch all for arrays not large enough
71h - 113 Invalid alias names for Vxd lookup
72h - 114 Invalid command
73h - 115 Invalid handle
74h - 116 Transfer not active
75h - 117 Acquisition not active
76h - 118 Invalid operation string used for triggering
77h - 119
Device with DSP failed communication
78h - 120 Device with EEPROM failed communication
79h - 121
Device using enhanced trigger detected invalid trigger type
7Ah - 122 User calibration constant out of range
7Bh - 123 Invalid error code
7Ch - 124 Invalid analog input voltage range parameter
7Dh - 125 Invalid calibration table type
7Eh - 126 Invalid calibration input signal selection
7Fh - 127 Invalid raw-data format selection
80h - 128 Feature/function not implemented yet
81h - 129 Invalid digital I/O device type
82h - 130 Invalid post-processing data format selection
83h - 131 Personal Daq low level driver stalled
84h – 132 Personal Daq device has lost power
85h – 133 Personal Daq device is not detected
86h – 134 Scan Configuration is invalid
Appendix B,
887095
Personal Daq User's Manual