Introduction; Pre-Installation Notes - Maxwell 6000 Series Manual

1.0

INTRODUCTION

1.1

PRE-INSTALLATION NOTES

• Read this manual thoroughly before installation
and using the windlass. Failure to adhere to
the correct procedures, recommendations and
guidelines described in this Owner's Manual
may invalidate the warranty.
• Be mindful that the correct selection of
windlass for each application, together with
correct installation, normal care in use and
maintenance, are essential for long life and
reliable performance.
• Inspect your windlass carefully when unpacked.
Any damage or lack of components should be
reported immediately to your Maxwell distributor.
• The windlass is supplied with chainwheel, as
specified on purchase order. Make sure it is the
appropriate one for the chain being used on
board. Correct fit of the chain to chainwheel is
essential for reliable and safe operation of the
windlass. This can be guaranteed only when
calibrated chain to a recognised international
standard is used and the chain is correctly
identified to Maxwell, or if a chain sample
is provided to Maxwell to develop a custom
chainwheel.
• The windlass is designed for use in conjunction
with chain stopper and tensioner of the
appropriate size. Their use is an important safety
feature.
• For side pocket anchors, a chain roller should
be installed above the hawse pipe to ensure
smooth and quiet travel of the chain from deck
to hawse pipe. The roller requires a central
groove to align chain and flat faces (for longer
chains) to support and avoid bending the chain
links.
• The connection of the power lines and control
circuitry to the windlass must be done by
skilled technicians, to ensure reliable and safe
operation of the windlass.
4