Ricoh P C600 User Manual page 96

3. Troubleshooting
Problem
Printing does not start.
Printing does not start.
Printing does not start.
94
Cause
If the printer is using wireless
LAN, failure to print might result
from a weak wireless signal.
If the printer is using wireless
LAN, when there is a
microwave oven, mobile phone,
industrial machine, scientific
instrument, or medical
instrument which uses the same
frequency range near the
device, radio waves may be
interfering with the wireless
LAN's communication.
If the printer is using wireless
LAN, SSID settings may be
incorrect.
Solution
Check the radio signal status of
the wireless LAN in [Host
Interface]. If the signal quality is
not satisfactory, move the
printer to a location where
radio waves can pass or
remove objects that might cause
interference.
You can check the signal status
only when wireless LAN is used
in infrastructure mode. For
details about the radio signal
status of the wireless LAN, see
"Checking the signal",
Operating Instructions.
Turn off the microwave oven,
mobile phone, industrial
machine, scientific instrument, or
medical instrument which uses
the same frequency range and
then try printing again. If
printing is successful, move the
device to a location where it
does not interfere.
Check that the SSID is correctly
set using the printer's display
panel. For details about SSID
Setting, see "Connecting to the
Wireless LAN Interface",
Operating Instructions.