ion science PhoCheck+ Series User Manual page 49

PhoCheck+ 1, 2, 3 & 5000 Ex
IS Protective Cover
Fitting Instructions
1. Insert instrument into the IS protective cover ensuring that the
probe tip exits through the small slit a t the top of the cover and
that the cover labelling and stickers are on the reverse of the
instrument.
2. Seal the cover at its base and lay the instrument on a flat
surface with the label and stickers facing upwards.
3. Peel off the backing to the large section of double-sided tape in
the middle of the instrument.
4. Gather the excess plastic on one side of the instrument and stick it
on the midway point of the double -sided tape.
5. Gather the excess plastic on the other side of the instrument and
stick it to the remainder of the double -sided tape.
6. Now remove the backing from one of the small pieces of tape and
secure it to the side of the instrument.
7. Remove the final piece of backing and secure it to the other side of the
instrument.
8. The instrument is now ready to use in Category 1 (zone 0) areas and in
applications where it is likely to get wet.
Page 48 of 52
Ion Science Ltd
__________