Advertisement
XD6220 (AXTVKIT)
23''-55''
50 lbs.
Supports VESA sizes up to: 400x400
For technical assistance or troubleshooting
please call 1-855-994-2825 or visit www.sibrandssupport.com
This product Wall Mount frame is intended for use only with an apparatus which has a maximum weight of 50 lbs. See apparatus
instructions. Using with an apparatus heavier than the maximum weight indicated may result in instability and cause possible
injury.
READ THIS FIRST Read this entire manual! Do not attempt to install this product if you do not understand the instructions.
Contact a qualified mount installer if you have any doubts about a safe and secure mount installation, or if you are not sure what
specific wall materials you are attaching this mount to. Check all the parts carefully to make sure there are no missing or
damaged parts. Improper installation may result in damage to your TV, property, and personal injury.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Atak XD6220
Summary of Contents for Atak XD6220
- Page 1 XD6220 (AXTVKIT) 23’’-55’’ 50 lbs. Supports VESA sizes up to: 400x400 For technical assistance or troubleshooting please call 1-855-994-2825 or visit www.sibrandssupport.com This product Wall Mount frame is intended for use only with an apparatus which has a maximum weight of 50 lbs. See apparatus instructions.
- Page 2 ATAK...
-
Page 3: Part List
Part List: 3- Wall Spacer 2- Bracket 2pcs 2pcs 1- Wall Plate Hardware list: 4 --Lag bolt 5--Anchor 6--M8 washer 7-- Allen wrench 8--Socket tool 2pcs 2pcs 2 pcs A--M4X12 bolt B--M5X12 bolt C--M6X12 bolt 4pcs 4pcs 4pcs D--M8X25 bolt E--M4X30 bolt F--M5X30 bolt G--M6X35 bolt... - Page 4 Center the Brackets (2) vertically on the rear of the TV. Attach the Brackets (2) to the rear of the TV using two of the bolts (A-H) with the proper size washers (I-J) as shown in Fig. 1. Do not over tighten. If the back of the TV is not flat, or if the bolts are too long, it may be necessary to use Spacers (K-N) as shown below.
- Page 5 1. Use a pencil, awl, or a nail to mark the location of the wall stud centers (Fig 2a) after locating the stud with an electronic stud locator. The distance between marks should not be less than 16 inches (Studs must not be less than 16 inches (40.6cm.) 2.
- Page 6 1. Place the Wall Plate flat against the wall with the center of the Wall Plate in the desired location, Use the Wall Plate as a template to mark the locatioin of the two mounting holes on the wall. Make sure that the mounting holes are level and are parallel. Make sure the holes are no closer than 16”...
- Page 7 Hang the TV 1. Using two people, lift the television display with the brackets and wall spacers securely attached up to the wall plate. 2. Hook the top of the Brackets (2) onto the top flange of the Wall Plate (Fig. 4), then swing the screen carefully down.
- Page 8 We warrant this product to you, the original purchaser at the time of purchase printed on a dated store receipt from an authorized ATAK retailer and for a period of six-years thereafter that our wall mount product and all it’s parts and components are free of defects in material and workmanship under normal use.
Need help?
Do you have a question about the XD6220 and is the answer not in the manual?
Questions and answers