Advertisement
Programming Guide
Step 5A: Designate pump to program (1, 2, or 3)
Press the pump you pick to program by
pressing the designated pump key on the
wireless remote.
Pump icon will illuminate on LED display.
Step 5B: Designate water flow mode
Press the FLOW mode you wish to run the pump
in by pressing the designated flow key on wireless
remote.
Flow icon will illuminate on the LED display.
Step 5C: Program the maximum FLOW
Press the increase/decrease FLOW keys to adjust
the pumps maximum flow rate until you have reached
the desired flow. FLO will illuminate on the LED display.
The RATE display will show the flow from 0-100% in
10% flow increments on LED display.
Step 5D: Designate FREQUENCY setting
If programming the pump in either SURGE or WAVE
mode, adjust the FREQUENCY setting by pressing
the increase/decrease FREQ keys on wireless remote
until the desired frequency/duration is reach.
The RATE display will show the
FREQUENCY in 10 settings
as follows:
Note: Decreasing FREQUENCY increases the time duration between min/max flow. It will appear
opposite in your aquarium (lowering frequency/duration will increase wave motion).
Your setting will automatically be saved into memory.
No additional keys need to be set to save your settings.
!
SURGE/GYRE
Frequency Setting
Pump ON
Wave/Pulse
Frequency Setting
Pump OFF
Page 8
eFlux Wave Pump Kit
"
#
STREAM
SURGE
WAVE
FLOW
FLOW
FREQ
FREQ
10s 15s 20s 25s 30s 40s 50s 70s 80s 90s
.7s
1s
2s 3s 4s
.3s .5s
1s
.3s
.5s .7s
2s
.3s
.5s .7s
2s
1s
5s 6s
7s
4s
3s
5s
6s
7s
3s
7s
4s
5s
6s
Advertisement
