Advertisement
Programming Guide
Step 1: Turning pumps ON/OFF
Press the Main ON/OFF key
pumps are on, LEDs on display will illuminate. If all pumps are turned off, all LEDs on display will
be off.
Step 2: Turning individual pumps ON/OFF
To individually turn each pump ON/OFF, hold the designated Pump Key
seconds. Pump will turn ON or OFF.
Step 3: LOCK / unlock remote
To Lock settings and IR remote communication, press Lock
key and hold for 5 seconds, the LED over LCK on the pump
display will turn green.
To unlock settings and IR remote communication, press Lock
key again for 5 seconds, the LED over LCK on the pump
display will turn off. The wireless remote will not operate and
communicate with the HUB and LED display.
Step 4: FEED Mode
To set all pumps into feeding mode, press the FEED Mode key
All pumps within the LOOP network will go into idle speed for 10 minutes.
After 10 minutes, all pumps will ramp back into their previously programmed
flow mode.
Step 5: Programming Flow Modes
Operational Flow Modes
There are three modes of water flow available for Pumps 1 and 2;Stream/Steady, Surge/Gyre and
Wave/Pulse. Note that Pump 3 is designated as a circulation pump and can only be programmed
in Stream/Steady Flow Mode.
STREAM/STEADY MODE
Flow rate is adjustable from
0-100% in 10% increments by
pressing:
FLOW
FLOW
to turn all of the pumps and pump display ON or OFF. When
When a pump is in Stream/Steady mode, the pump will constantly circulate
water at the programmed speed.
100%
Flow
50%
0
Page 6
eFlux Wave Pump Kit
!
LOCK
LED ON = Locked
LOCK
LED OFF = Unlocked
.
FEED
Display remains same
during FEED Mode
TIME
for 5
"
#
Advertisement
