Matco Tools Megajump Manual page 7

Jump start 12V vehicle Instruction (a)
1. Make sure that the unit is showing no less than 3 lights on the LED charge indi-
cator display before using as a jump-starter.
2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect
the BLACK clamp to the vehicle's negative (-) terminal.
3. Plug the cord of jumper cable into the jump start socket port.
4. Check indicator light on the clamps, Green light means ready to go; then start
the vehicle (otherwise please check the connection).
5. When the vehicle is started, remove the jumper cable from the device and dis-
connect RED and BLACK clamps from vehicle battery terminals.
6. Leave the vehicle's engine running.
7. DO NOT ATTEMPT TO DRIVE VEHICLE WITH THIS DEVICE CONNECTED
TO THE BATTERY , OR LEAVE ATTACHED TO THE BATTERY OF A RUN-
NING VEHICLE.
Charging Cell Phone or Tablet Instruction (b):
1. Plug the switch cable to USB 5V/2.1A output port.
2. Select the appropriate connector for your cell phone or tablet and connect it to
any of them. This device can identify and charge your electronic device auto-
matically. The indicators will be on when the device is charging.
C. LED Flashl ight
1. Press the switch 3 seconds to turn on/off the LED Flashlight.
2. There are 3 modes of LED torch: Normal light, Strobe, SOS, which can be shifted in turns
by pressing the switch.
3. Press the switch 3 seconds to turn off the LED Flashlight no matter you are in any mode.
D. LED panel light
1. Press the switch 3 seconds to turn on the LED panel light.
2. There are 2 modes of LED light: Normal light, red and white flashing light, which can be
shifted in turns by pressing the switch.
3. Press the switch 3 seconds to turn off the LED panel light no matter you are in any mode.
12V/10A DC Output Port
E.
1. Plug DC adapter into 12V DC port and connect desired device for use.
2. Disconnect device and DC adapter when not in use.
How To Use The Jump Starter
Page 7