Standard Packing Contents; Quick Installation - YLINK 1GE+WIFI EPON ONU User Manual

2.1 Standard Packing Contents

When you receive our products, please check carefully to make sure that our products
whether have some defects or not. If something wrong with shipping, please contact carrier;
other damage or lack of some parts, please contact with dealer.
Contents
ONU
Power Adapter
User Manual

2.2 Quick Installation

1. Connecting the optical fiber cable to the unit.
a) Remove the protective cap of the optical fiber.
b) Clean the end of the optical fiber with an optical fiber end cleaner.
c) Remove the protective cap of the ONU optical interface (PON interface). Connect the
fiber to the PON port on the unit.
Note: When measuring the optical power before connecting to the ONU, it is
recommended to use a PON Inline Power Meter.
While connecting, please note:
Keep the optical connector and the optical fiber clean.
Make sure there are no tight bends in the fiber and that the bending diameter is greater
than 6cm. Otherwise, the optical signal loss may be increased, to the extent that signal
may be unavailable.
Cover all optic ports and connectors with protective cap to guard against dust and
moisture when the fiber is not used.
2. Apply power to the unit. Push the power button.
3. After the ONU is power ON, Indicators should light up as for normal operation. Check
whether the PON interface status LED (PON) is on continuously. If it is, the connection is
normal; otherwise there is either problem of the physical connection or the optical level at
Chapter 2 Quick Installation
Page 5
1GE+WIFI EPON ONU USER MANUAL
Description
1 pc
1 pc
1 pc