Automatic Climate Control - Mazda CX-9 2010 Smart Start Manual

Automatic Climate Control

Driver Temperature Control Dial
AUTO ON: Push dial to turn Automatic Air Conditioning system on. Rotate
dial to select your desired set temperature (shown in information Display
above). The air ow and amount of air ow will be automatically controlled
in accordance with the set temperature.
Passenger Temperature Control Dial
Push to turn DUAL mode ON/OFF.
• With DUAL mode ON (indicator on), rotate the dial to set passenger
side (shown in the Information Display above).
• With DUAL mode OFF (indicator off), driver controls the temperature
setting on both sides.
Automatic climate control will allow you to maintain individual preset cabin
temperatures for the driver and passenger when DUAL mode is selected.
NOTE:
Automatic Temperature control always works even if Auto indicator comes
off by rotating fan speed or changing vent mode.
15
INFORMATION DISPLAY
Push to manually turn
air conditioning ON or OFF.
Push to select the desired
MODE
air ow mode.
OUTSIDE Push to display outside
TEMP
temperature. Push and hold
for three seconds or longer
to switch from Fahrenheit
and Celsius or vice versa.
OFF Push to turn climate
control system off.
Push to defrost the windshield.
FRONT
Rear Climate Control Operation from Front Seats
1 Turn the front air conditioning on.
2 Push the REAR control button on the front
control panel (indicator on).
3 Selection of the air ow mode, air ow amount
and temperature will be automatically controlled
to the same setting as the front air conditioner.
NOTE:
If the rear AUTO button is pushed while the front A/C button is off, the rear
air conditioning operates only to circulate air. Setting the temperature to the maximum
high or low will not provide the desired temperature at a faster rate.
FRONT SEAT WARMERS
The driver and front passenger
seats can be warmed by pushing
the applicable seat warmer button
while the ignition is ON.
• Seat temperature increases as
the number of indicator lights
increases. Two lights equal
high, one light equals low.
• When the seat warmers are
not needed, push button until
indicator lights are off.
Push to defrost the
REAR
rear window.
REAR Push to allow control from the
rear controls (indicator on).
Rotate dial to turn the
system ON and to select
the desired fan speed.
Push to recirculate cabin air
to reduce outside odors and
improve cooling (indicator
on) or receive fresh air
(indicator off).
16